8.Remove door strike (E) from cabinet. Use a small,
9.Insert screws into bottom holes on left side of cabinet. Tighten screws halfway. Position door so large end of door hinge slot is over screws. Slide door up so screws are in bottom of slots. Tighten screws. Insert and tighten top screws in hinges.
10.Remove door strike plug (B). Insert the door strike you removed in Step 8 into hole and secure with screw. Insert door strike plug into original door strike hole and secure with screw.
11.Close door and check that door strike aligns with door catch (C). If it is needed, slide door catch left or right within slot to adjust alignment.
27" Wide Models
Reversible Side-Swing Door
Appearance may vary
A
C
D
B
1.Place towel (A) on top of dryer to avoid damaging the surface.
2.Open dryer door. Remove bottom screws from cabinet side of hinges (B). Loosen (do not remove) top screws from cabinet side of hinges.
3.Lift door until top screws in cabinet are in large part of hinge slot. Pull door forward off screws. Set door (handle side up) on top of dryer. Remove top screws from cabinet.
4.Remove screws attaching hinges to door.
5.Remove screws at top, bottom, and side of door (4 screws). Holding door over towel on dryer, grasp sides of outer door and gently lift to separate it from inner door. Do not pry apart with putty knife. Do not pull on door seal or plastic door catches.
6.Be certain to keep cardboard spacer centered between doors. Reattach outer door panel to inner door panel so handle is on the side where hinges were just removed.
7.Attach door hinges to dryer door so that the larger hole is at the bottom of the hinge.
8.Remove the 4 screws that attach 2 plugs (D) on the left side. Attach plugs to right side using the same 4 screws.
9.Insert screws into bottom holes on left side of cabinet. Tighten screws halfway. Position door so large end of door hinge slot is over screws. Slide door up so screws are in bottom of slots. Tighten screws. Insert and tighten top screws in hinges.
10.Close door and check that door strike aligns with door catch (C). If it is needed, slide door catch left or right within slot to adjust alignment.
13