INSTALLATION REQUIREMENTS
Tools and Parts
Gather the required tools and parts before starting installation. Read and follow the instructions provided with any tools listed here.
■■ | ■■ 1/4" nut driver or socket | ||
■■ | #2 Phillips head |
| wrench (recommended) |
|
| ||
| screwdriver | ■■ Tin snips (new vent | |
■■ Adjustable wrench that |
| installations) | |
|
| ||
| opens to 1" (25 mm) or | ■■ | Caulking gun and |
|
| compound (for installing | |
| (for adjusting dryer feet) |
| new exhaust vent) |
■■ | Level | ■■ | Tape measure |
■■ | Vent Clamps | ■■ | Utility knife |
■■ | Pliers |
|
|
Gas Installations |
|
| |
■■ 8" or 10" pipe wrench | ■■ | Pipe joint compound | |
■■ 8" or 10" adjustable |
| resistant to LP gas | |
|
| ||
wrench
Parts supplied:
Parts package is located in dryer drum. Check that all parts are included.
4 Leveling legs
Parts needed:
Check local codes. Check existing electrical supply and venting, and read “Electrical Requirements” and “Venting Requirements” before purchasing parts.
Mobile home installations require metal exhaust system hardware. For further information, please reference the “Assistance or Service” section of the “Dryer User Instructions.”
Location Requirements
You will need:
■■ A location allowing for proper exhaust installation. See “Venting Requirements.”
■■ A separate 30 amp circuit for electric dryers. ■■ A separate 15 or 20 amp circuit for gas dryers.
■■ If you are using power supply cord, a grounded electrical outlet located within 2 ft. (610 mm) of either side of dryer. See “Electrical Requirements.”
■■ A sturdy floor to support dryer and a total weight (dryer and load) of 200 lbs. (90.7 kg). The combined weight of a companion appliance should also be considered.
■■ Level floor with maximum slope of 1" (25 mm) under entire dryer. If slope is greater than 1" (25 mm), install Extended Dryer Feet Kit, Part Number 279810. If not level, clothes may not tumble properly and automatic sensor cycles may not operate correctly.
Do not operate your dryer at temperatures below 45°F (7°C). At lower temperatures, the dryer might not shut off at the end of an automatic cycle. Drying times can be extended.
The dryer must not be installed or stored in an area where it will be exposed to water and/or weather.
Check code requirements. Some codes limit, or do not permit, installation of the dryer in garages, closets, mobile homes, or sleeping quarters. Contact your local building inspector.
NOTE: No other
4