Dakota Digital MMX-6 operation manual Dakota Ultrasonics

Page 2

Dakota Ultrasonics

Copyright  2002 Dakota Ultrasonics. All rights reserved.

No part of this publication may be reproduced, translated into another language, stored in a retrieval system, or transmitted in any form or by any means; electronic, mechanical, photocopying, recording, or otherwise, without the prior written consent of Dakota Ultrasonics.

Every precaution has been taken in the preparation of this publication. Dakota Ultrasonics assumes no responsibility for errors or omissions. Neither is any liability assumed for damages resulting from the use of information contained herein.

Any brand or product names mentioned herein are used for identification purposes only, and are trademarks or registered trademarks of their respective holders.

1650 Mansfield Street, Santa Cruz, California, 95062 USA

Tel (831) 465-8585 Fax (831) 465-8558

http://www.dakotaultrasonics.com

Image 2

Contents Dakota Ultrasonics Dakota Ultrasonics Contents Disclaimer Very Important Introduction Blank Operation KeypadDakota Ultrasonics MMX-6 DL Ultrasonic Thickness Gauge Dakota Ultrasonics Display Dakota Ultrasonics Is currently operating in echo-echo Thru-paint/coating mode Transducer Making Measurements Dakota Ultrasonics Condition and Preparation of Surfaces Probe Zero Performing a Probe-ZeroCalibration Dakota Ultrasonics Calibration to a known thickness Dakota Ultrasonics Calibration to a known velocity Dakota Ultrasonics Two Point Calibration MMX-6 DL Modes Changing Units in / MM Units in/mmBack light Using The Back LightScan Mode Using Scan Mode Alarm ModeUsing the Beeper Dual-Multi Mode Connecting To a Computer RS232 Serial Port & The Data LoggerUsing The Data Logger Using the Data Logger Clearing a Storage Location Clearing an Entire File Clearing all Files Sending All Files to a ComputerPrinting a File Transducer Selection MMX-6 DL Ultrasonic Thickness Gauge Dakota Ultrasonics Blank Appendix a Product Specifications PhysicalPower Source KeypadMeasuring hot surfaces Appendix BApplication Notes Measuring pipe and tubing Measuring laminated materials Measuring Through Paint & Coatings Blank Appendix C Sound Velocities of some Common MaterialsBlank Warranty Information Warranty Statement