Dakota Digital operation manual MMX-6 DL Modes Changing Units in / MM, Units in/mm

Page 26

Dakota Ultrasonics

8)Press the Probe key. The display will flash 1OF2. Repeat steps 3 through 7 on the second calibration point. The MMX-6 DL will now display the sound velocity value it has calculated based on the thickness values that were entered in step 7. The MMX-6 DL is now ready to perform measurements within this range.

MMX-6 DL Modes

Changing Units IN / MM

The MMX-6 DL has the ability to display measurements in both the English (IN) and Metric (MM) systems. The following steps outline the procedure for changing units:

Units in/mm

1)Press ON/OFF key to power up the MMX-6 DL.

2)Press the MODE key to activate features and settings.

3)Press the UP or Down arrow keys to scroll to the unIt symbol.

4)Press the SEND key to toggle the status of the units - IN / MM.

5)Press the MODE key once again to return to measurement mode.

22

Image 26

Contents Dakota Ultrasonics Dakota Ultrasonics Contents Disclaimer Very Important Introduction Blank Operation KeypadDakota Ultrasonics MMX-6 DL Ultrasonic Thickness Gauge Dakota Ultrasonics Display Dakota Ultrasonics Is currently operating in echo-echo Thru-paint/coating mode Transducer Making Measurements Dakota Ultrasonics Condition and Preparation of Surfaces Probe Zero Performing a Probe-ZeroCalibration Dakota Ultrasonics Calibration to a known thickness Dakota Ultrasonics Calibration to a known velocity Dakota Ultrasonics Two Point Calibration MMX-6 DL Modes Changing Units in / MM Units in/mmBack light Using The Back LightScan Mode Using Scan Mode Alarm ModeUsing the Beeper Dual-Multi Mode Connecting To a Computer RS232 Serial Port & The Data LoggerUsing The Data Logger Using the Data Logger Clearing a Storage Location Clearing an Entire File Clearing all Files Sending All Files to a ComputerPrinting a File Transducer Selection MMX-6 DL Ultrasonic Thickness Gauge Dakota Ultrasonics Blank Appendix a Product Specifications PhysicalPower Source KeypadMeasuring hot surfaces Appendix BApplication Notes Measuring pipe and tubing Measuring laminated materials Measuring Through Paint & Coatings Blank Appendix C Sound Velocities of some Common MaterialsBlank Warranty Information Warranty Statement