Dakota Digital MMX-6 operation manual Using the Data Logger

Page 33

MMX-6 DL Ultrasonic Thickness Gauge

Using the Data Logger (con't)

•The current file will be diplayed ( F-01, F-03, etc. )

4)Press the UP / DOWN arrow keys to scroll to the file ( 1-10 ) that will be used to record the measurements.

5)Press the SEND key once again to select the file.

Note:

•The display will flash the FILE / F-04( The selected file )symbol.

6)Press the MEM key, once again, to advance to the storage locations in the file selected.

Note:

•The display will flash the current storage location ( L007, L039, etc. ), followed by the status of the location. The storage location can contain one of three possible things: a) a measurement that was previously stored. b) A clear location, indicated by the CLr symbol. c) Obstruct ( ObSt ), indicating that a measurement could not be obtained.

7)Press the UP / DOWN arrow keys to advance to the desired cell location.

8)Take a measurement and press the SEND key to store a reading in the desired location.

Note:

•The data logger will automatically advance to the next storage location in sequential order.

9) Repeat step 8 as required.

29

Page 32 Page 34
Image 33
Page 32 Page 34
Contents Dakota Ultrasonics Dakota Ultrasonics Contents Disclaimer Very Important Introduction Blank Keypad OperationDakota Ultrasonics MMX-6 DL Ultrasonic Thickness Gauge Dakota Ultrasonics Display Dakota Ultrasonics Is currently operating in echo-echo Thru-paint/coating mode Transducer Making Measurements Dakota Ultrasonics Condition and Preparation of Surfaces Performing a Probe-Zero Probe ZeroCalibration Dakota Ultrasonics Calibration to a known thickness Dakota Ultrasonics Calibration to a known velocity Dakota Ultrasonics Two Point Calibration Units in/mm MMX-6 DL Modes Changing Units in / MMUsing The Back Light Scan ModeBack light Alarm Mode Using Scan ModeUsing the Beeper Dual-Multi Mode RS232 Serial Port & The Data Logger Connecting To a ComputerUsing The Data Logger Using the Data Logger Clearing a Storage Location Clearing an Entire File Sending All Files to a Computer Clearing all FilesPrinting a File Transducer Selection MMX-6 DL Ultrasonic Thickness Gauge Dakota Ultrasonics Blank Power Source Product Specifications PhysicalAppendix a KeypadAppendix B Application Notes Measuring pipe and tubingMeasuring hot surfaces Measuring laminated materials Measuring Through Paint & Coatings Blank Sound Velocities of some Common Materials Appendix CBlank Warranty Statement Warranty Information
Top Page Image Contents