30
Customizing
Saving and sending/setting configurations
With the Edge, there are saved setup profiles used to quickly access and apply to The Edge(s). Below explains how to save configuration settings in DMS and how to send/set to the instrument. Note: if you wish to only send the setup, please skip to step 3. Please refer to this section as you setup your instrument.
1.To save the Edge configuration in the software, click on a name in the Configuration Profile Management panel (See 1). Note: The name will be shaded a light gray when selected.
∙To create a new profile name, click 
and type in a profile name. Click Save. (It will save under the configuration profile management panel).
2.Click on the 
button (see 2) and type in a Name. Click Ok.
∙Note: This saves the configuration file in the software.
∙Or click 
button and rename the setting by typing in a name. Click Ok.
3. To send to the instrument, select the 
(see 3).
1
2
3
Figure 3-11: Saving and sending Edge setups
Page 30 | eg4 & eg3 |