Standard Horizon CP500 owner manual Troubleshooting

Page 77

16. TROUBLESHOOTING

The GPS Chart Plotter does not turn On. The voltage or the polarity may not be correct. Make sure that the correct voltage (10-35 volt dc) is present. Check also that the polarity is correct.

The GPS Chart Plotter does not get a valid fix. The GPS WAAS Smart Antenna may not be in a open sky position or the antenna cable may not be properly connected. Make sure that no metal obstacle is placed around the antenna acting as a shield for the antenna and disconnect and connect again the antenna cable to the GPS Chart Plotter. If, after 15 minutes, the GPS Chart Plotter does not get the fix, turn it Off and On again.

The GPS Chart Plotter does not turn Off. Pressing [PWR] (for at least 3 seconds) the GPS Chart Plotter does not turn Off, turn Off the voltage. Perform RAM clear. Refer to section 17.0.0 RAM Menu (reset).

The GPS Chart Plotter screen becomes very dark after a long exposure to direct sunlight. The internal temperature is very high. Control the contrast. Protect the GPS Chart Plotter from direct sunlight.

The GPS Chart Plotter does not respond to any command. Try to turn Off, and then turn On. If the problem persists, reset the RAM (refer to section 17.0.0 RAM Menu (reset)) or remove power from the battery.

The location of my fix is not shown correctly on the Chart page. This is usually caused when C-MAPGeo-References a nautical chart. Contact C-MAP with the Latitude & Longitude of your vessels position, the position where you think your vessels should be and with details of the cartography areas, which can be seen by selecting the Chart page, press [INFO], move the ShuttlePoint knob to Data Source and press [ENT]. Write down the “Compilation scale”, “Notice to mariners” and “Horizontal datum”. Next contact C-MAP USA at 508/477-8010 and advise the problem.

After storing the Chart Plotter over the winter, It takes a long time to receive a fix. This is usually caused by the internal rechargeable memory battery from becoming low which could cause the Internal RAM memory to become corrupted. To solve this issue, perform a RAM clear (refer to Section 17).

NOTE

After performing a RAM Clear all Marks, Routes and tracks will be erased. To back up these points refer to Section 11 for details.

CP500

Page 79

Page 76 Page 78
Image 77
Page 76 Page 78
Contents CP500 FCC Compliance Statement Cleaning Procedure for the GPS Chart Plotter Screen CP500 Table of Contents Tracks RoutesUser C-CARD PagesAppendix Terms Analitycal Index SpecificationsTechnical Tests CP500 General Information IntroductionPacking List Part CodeModel Number Description Optional Accessories Radar Unit Supplied by SI-TEX USAGetting Started Mounting the GPS Chart PlotterBracket Mounting MenuFlush mounting the antenna External GPS Antenna MountingGPS cable Battery ConnectionsGPS antenna connections PWR & ACC 1 CableBOX Fish Finder Nmea ConnectionsSetting UP the COM Port Personal Computer Connection / SetupSelect SEND/REC RTE&MARKS and press ENT Send or Receiving RTE and WPLVGA Video Output ACC 2 ConnectorVHF Connections · Two Ntsc or PAL Video Inputs · One VGA outputQuick Activation by Soft Keys Quick Activation by pressing CLR for 1 secondControls and Connections Controls and IndicatorsAlphanumeric keys Getting Started Power On, Off and ShuttlePoint knob operationCursor Mode Cursor Vs. Home ModeHome mode Cursor and Menu selection speedSelecting North Up or Course Up Changing the backlight and contrastAdjusting Time Adjusting the TimeSelecting Loran TD or Other Coordinate System Changing the Chart ColorCustomizing the Soft Keys Selecting Pages with Soft KeysTime Setup Other Settings in General Setup MenuDate Format Keypad BeepAbout Other Available Searches Using Find Services & More FunctionPort Services Full Info On Lakes Info on LakesQuick Info On Lakes 1a Example of picture associated to the Fishing object CP500 New Presentation Features New Data FeaturesMAP MAX Overview Inserting the C-CARDCP500 MAP Functions Fonts & SymbolsMAX Functions Menu Zoom TypeDynamic Nav-Aids Perspective ViewZoom Data Off Currents PredictionHow to show the pictures or diagrams of a Multimedia Object Pictures & DiagramsEnhanced Port Info Creating Marks Creating a NEW Mark Using the ChartEditing a Mark MarkMoving a Mark or Waypoint Deleting a Mark or WaypointMARKS/WAYPOINTS List Goto Cursor CREATING/MODIFY a NEW Mark in the User Points ListGoto Cursor Goto Mark Goto RouteCP500 Deleting a MOB Point MAN Over Board MOB FunctionPlacing a MOB Point CP500 Changing Name to a Route Creating a Route Using WaypointsRoutes Making Additional Routes Creating a Route Using Marks on the ChartInserting a Waypoint Into a Route Other Settings in Route MenuGoto a Route By select RouteCP500 Tracking TracksUsing the Trip LOG Other Settings in Track MenuSaving and starting a new Track ENTResetting the Trip Log CP500 Formatting the User C-CARD User C-CARDUser C-CARD Menu Loading a file Transferring files to the optional User C-CARDDeleting a file from the User C-CARD Changing the User C-CARD· Selection by Soft KEY Pages· Selection by Menu Window Selections ChartAdditional Functions on Chart Turning Off Information on Icon Points Display Mode12.0.3.1 Depth Settings 12.0.3.0 Marine Settings12.0.3.2 Land Settings 12.0.3.3 Chart SettingsCustomizing the Data Windows Customizing the Map ConfigurationsUnderwater Object Settings Highway NavigationGPS Status CelestialChanging date Changing to and from Daylight Savings timeChanging the Nmea page Windows Nmea DisplayVHF Digital Selective Calling Nmea DataNmea DEPTH, Wind SPEED, Temp and SOG Trend Pages Position Request DSC Distress CallNavigate Advanced SettingsINPUT/OUTPUT Nmea Connection Compass AlarmsGrounding Alarm CP500 AIS System Definitions AISQuick Info on AIS Target To SET the Chart Plotter for Receiving AISAIS Menu Load From File MAP Weather ServiceMAP Weather Service Menu Type of Data ForecastReal Time View Troubleshooting CP500 Technical Tests RAM Menu resetSystem Test DIM MenuBacklight Card ConnectorInternal Data Base Test Card TestMAP NT +/MAX C-CARD SpecificationsCP500 Flush Mount cutout Dimensions are in mm Physical Characteristics GPS Waas Smart Receiver SpecificationsCP500 Appendix Terms Page Altitude Analitycal IndexMAX Overview A N D a R D H O R I Z O N L I M I T E D W a R R a N T Y Please Note
Related manuals
Manual 42 pages 55.96 Kb

CP500 specifications

Standard Horizon is well known for its innovative marine electronics, particularly its line of chart plotters and multifunction displays. Among its popular products are the CPV550, CP500, CP180I, CP180, and CP300 models, each designed to enhance navigational experience for boaters and sailors.

The Standard Horizon CPV550 is a cutting-edge chart plotter that features a bright, high-resolution 5.5-inch color display. This model supports Navionics and C-MAP charts, ensuring users have access to high-quality cartography. Its built-in GPS receiver offers exceptional accuracy and fast position fixes, while its user-friendly interface allows for easy navigation through menus and functions. The CPV550 is equipped with a variety of connectivity options, including NMEA 0183, allowing for seamless integration with other onboard electronics.

The CP500 is another robust option, featuring a 5-inch display and advanced GPS technology. This model is designed for ease of use, with a straightforward interface that appeals to both novice and experienced users. It offers real-time tracking and position monitoring, making it ideal for coastal cruising and fishing. The CP500 supports various cartography formats, providing flexibility for users who prefer different map sources.

Moving on, the CP180I model stands out with its innovative integrated design, packing a 7-inch display and multiple advanced features into a compact unit. It includes built-in Wi-Fi, allowing users to connect their mobile devices and access updates or weather information directly from the display. The CP180I is also compatible with a wide range of NMEA 2000 devices, offering greater customization options for boaters looking to expand their electronic setups.

The CP180 offers similar capabilities but focuses on a slightly larger 8-inch screen. This model enhances visibility and provides an intuitive experience with its touch-screen interface. It supports various navigation modes and features such as AIS overlay and radar integration, which significantly improve situational awareness on the water.

Finally, the Standard Horizon CP300 is a versatile chart plotter that combines advanced features with exceptional user-friendliness. This model features a 9-inch display that offers crisp visuals and enhanced readability even in bright sunlight. It also stands out for its robust integration capabilities with other marine instruments. The CP300 includes built-in Bluetooth and Wi-Fi, allowing for wireless data sharing and connectivity with smart devices.

Overall, the Standard Horizon line of chart plotters, including the CPV550, CP500, CP180I, CP180, and CP300, offers advanced technological features, reliable performance, and user-friendly interfaces, making them excellent choices for both leisure and professional mariners alike. With a focus on connectivity, visibility, and customizable options, these devices enhance the navigation experience on the water.
Top Page Image Contents