Mustang Survival MD3087 manual Usage Below Freezing, Re-arming Your PFD MD3085

NOTE: The service indicator must be green before proceeding.

4) Your device is ready to be repacked (see Repacking p. 13).

FIGURE 5

Cap In

Deflate

Position

FIGURE 6

Oral Inflator
Dust cap	Dust cap
in stowed	position for
position	deflation

Usage Below Freezing

When the temperature is below freezing, the Inflatable PFD should be worn partially inflated because a fully discharged cylinder may not quickly or adequately inflate your Inflatable PFD. Under these conditions use the oral inflator to adequately top-up the PFD, after CO2 inflation.

WARNING: CO2 inflation could over-pressurize and damage your Inflatable PFD if already fully inflated.

Re-arming Your PFD (MD3085)

NOTE: A re-arm kit (MA7203) is required for this procedure.

IMPORTANT: Follow instructions in the exact sequence below.

1)Unpack or open the Inflatable PFD so that the manual inflator is exposed (Fig. 7).

2)Remove the cylinder/bayonet assembly by rotating counterclockwise and then pull out. Discard the used cylinder/bayonet assembly.

3)Check the new cylinder/bayonet assembly to ensure the o-ring is in

place and the sensor ring is attached (Fig. 10). Ensure that the CO2 cylinder has not been pierced (Fig. 10).

Inflatable PFD Owner’s Manual 8