NAVI/AV
Symptom | Cause | Action (See) | ||
| The navigation unit is installed with | Confirm the installation angle. (The | ||
| an extreme angle exceeding the limi- | Navigation System must be installed | ||
| tation of the installation angle. | within the allowed installation angle. | ||
|
| For details, refer to “Installation Man- | ||
|
| ual” and “Installation Angle Setup” | ||
|
| on page 62.) | ||
| Indication of the position of your | Check whether or not the reverse | ||
| vehicle is misaligned after a | gear signal input lead (purple) is con- | ||
| reversing. | nected properly. (The Navigation Sys- | ||
|
| tem works properly without the lead | ||
|
| connected, but positioning accuracy | ||
|
| will be adversely affected.) | ||
|
|
|
|
|
The map continually reorients itself. | The traveling direction is always set | Touch |
| on the screen and change |
| to Heading Up. | the map | display. | |
Tracking marks are not displayed. | The “Tracking Display” is turned | Check the “Tracking Display” set- | ||
| off. | tings (➞ Page 65) and make sure |
“Always” or “This Trip” is selected.
The daylight display is used even when the vehicle lights are on.
Daytime is selected on “Day/Night Display”.
Check the “Day/Night Display” set- ting (➞ Page 65) and make sure “Nighttime” is selected.
Appendix
| The Orange/white lead is not con- | Check the connection. |
| nected. |
|
The display is very dim. | The vehicle’s light is turned ON, and | Read about the “Day/Night Dis- |
| “Nighttime” is selected on “Day/ | play” setting (➞ Page 65) and, if |
| Night Display”. | desired, select “Daytime”. |
|
|
|
| The vehicle cabin temperature is | A Liquid Crystal Display (LCD) is |
| extremely low. | used, and such displays tend to |
|
| darken when cold. Wait for the vehi- |
|
| cle to warm up. |
| Picture quality adjustment of the dis- | Refer to “Operating the Picture |
| play is not correct. | Adjustment” (➞ Page 104) to adjust |
|
| the picture quality. |
|
|
|
| Ambient light sensor of the display is | Set the ambient light sensor not to |
| hidden. | be hidden or switch the “DIMMER” |
|
| to “ILLUMI” in the SETUP menu. |
|
|
|
No sounds are heard. | The volume level is low. | Adjust the volume level. |
The volume level will not rise. |
|
|
The attenuator or mute is on. | Turn the attenuator or mute off. | |
| The speaker lead is disconnected. | Check the connection. |
|
|
|
Adjusting the volume of navigation | You cannot adjust them with VOL | Turn the volume up or down accord- |
guidance and beep is not possible. | ing to “Volume” (➞ Page 63) in the | |
|
| Setting menu. |
Slope is not displayed on the Vehicle Dynamics screen. Inclination does not move on the 3D Calibration screen.
The speed pulse lead is not con- nected.
Connect the speed pulse lead.
When the screen is frozen...
Park your vehicle at a safe place, and cut the engine off. Turn the ignition key back to “Acc off”. Then start the engine again, and turn the power to the navigation unit back on. If this does not solve the problem, press the RESET button on the navigation unit.
116