Pioneer AVIC-D1 operation manual Messages and how to react to them, 118

NAVI/AV

Messages and how to react to them

The following messages may be displayed by your Navigation System.

❒There are occasions when you may see error messages other than those shown here. In such a case, follow the instructions given on the display.

Message

Please insert the appropriate disc.

This is not the appropriate disc. Please insert the appropriate disc.

When	What to do
If you try to use a disc which is	Insert a suitable disc.
incompatible with this system.
If you insert a disc upside down.	Insert the disc with the label upward.
If the disc is dirty.	Clean the disc.
If the disc is cracked or otherwise	Insert a normal, round disc.
damaged.

Irregular speed pulse signal is	If the Navigation unit does not	Consult your Pioneer dealer.
detected. Please power off the sys-	receive the vehicle speed pulse.
tem and check the installation. After
you have checked, please re-boot the
system and press “OK”.

Appendix

Speed pulse wire is not connected. System will start to learn without speed pulse. Please keep in mind that accuracy is not fully ensured without speed pulse.

The speed signal input (pink lead wire) of the power cable is not con- nected.

To operate with 3D hybrid mode, con- nect the speed signal input (pink lead wire) of the power cable cor- rectly.

Although it can be operated with Simple hybrid mode without con- necting the speed signal input, the precision of the positioning will be less accurate.

Vibration is detected. Please power	While the vehicle is stationary, the	Re-install the navigation unit of the
off the system and check the installa-	Navigation System is installed in a	Navigation System in a place where
tion. After you have checked, please	place where the navigation unit may	the navigation unit will not be
re-boot the system and press “OK”.	be affected by a large vibration.	affected by vibration.
Direction of G sensor is not correct.	Direction of G sensor is set incor-	See the “Installation Manual” and set
Please power off the system and	rectly.	the direction of the Hide-away unit
check the installation. After you have		correctly.
checked, please re-boot the system
and press “OK”.
Gyro Sensor is not working properly.	Abnormal output of Gyrosensor is	Note down the error code shown on
Please consult your dealer or Pioneer	detected.	the screen; turn off the power, and
service center.		then contact your nearest Pioneer
		service facility.
This function is not available now.	The screen cannot be displayed with	If the sensor learning status reaches
	Vehicle Dynamics Display.	the Sensor Initializing status or more,
	Because the sensor has not been	the system is ready to be used.
	taught so the sensor information
	cannot be acquired.
System detected that the vertical	If the mounting angle of the Hide-	The system initializes the sensor in
angle of the installation has been	away unit has been changed.	order to operate it with the maximum
changed. Learning status for Gyro		performance and automatically
Sensor has been initialized.		starts re-learning.
System detected that the vertical	The navigation unit is installed with	Confirm the installation angle. (The
angle of the installation exceeds the	an extreme angle exceeding the limi-	Navigation System must be installed
permission level. Please install the	tation of the installation angle.	within the allowed installation angle.
navigation unit correctly.		For details, refer to “Installation Man-
		ual” and “Installation Angle Setup”
		on page 62.)
No data available at this time.	If no data is available that can be	Wait for a while and try the operation
	used with the XM tuner.	again.

118