SUPER MICRO Computer H8DMT user manual 82h

:

Checkpoint	Code Description
82h	The keyboard controller interface test completed. Writing the command byte and
	initializing the circular buffer next.
83h	The command byte was written and global data initialization has completed.
	Checking for a locked key next.
84h	Locked key checking is over. Checking for a memory size mismatch with CMOS
	RAM data next.
85h	The memory size check is done. Displaying a soft error and checking for a
	password or bypassing WINBIOS Setup next.
86h	The password was checked. Performing any required programming before
	WINBIOS Setup next.
87h	The programming before WINBIOS Setup has completed. Uncompressing the
	WINBIOS Setup code and executing the AMIBIOS Setup or WINBIOS Setup
	utility next.
88h	Returned from WINBIOS Setup and cleared the screen. Performing any
	necessary programming after WINBIOS Setup next.
89h	The programming after WINBIOS Setup has completed. Displaying the power on
	screen message next.
8Ch	Programming the WINBIOS Setup options next.
8Dh	The WINBIOS Setup options are programmed. Resetting the hard disk controller
	next.
8Fh	The hard disk controller has been reset. Configuring the floppy drive controller
	next.
91h	The floppy drive controller has been configured. Configuring the hard disk drive
	controller next.
95h	Initializing the bus option ROMs from C800 next. See the last page of this
	chapter for additional information.
96h	Initializing before passing control to the adaptor ROM at C800.
97h	Initialization before the C800 adaptor ROM gains control has completed. The
	adaptor ROM check is next.
98h	The adaptor ROM had control and has now returned control to BIOS POST.
	Performing any required processing after the option ROM returned control.
99h	Any initialization required after the option ROM test has completed. Configuring
	the timer data area and printer base address next.
9Ah	Set the timer and printer base addresses. Setting the RS-232 base address next.
9Bh	Returned after setting the RS-232 base address. Performing any required
	initialization before the Coprocessor test next.
9Ch	Required initialization before the Coprocessor test is over. Initializing the
	Coprocessor next.
9Dh	Coprocessor initialized. Performing any required initialization after the
	Coprocessor test next.
9Eh	Initialization after the Coprocessor test is complete. Checking the extended
	keyboard, keyboard ID, and Num Lock key next. Issuing the keyboard ID
	command next.
A2h	Displaying any soft errors next.

B-5