H8DMT/H8DMT-IBX/H8DMT-F/H8DMT-IBXF User’s Manual
| Table | |
|
|
|
Menu Item |
| Description |
|
| Use the "+" and |
CPU Overheat |
| and 90o C. When this threshold is exceeded, the overheat LED on the chassis |
| will light up and an alarm will sound. The LED and alarm will turn off once the | |
Alarm |
| |
| CPU temperature has dropped to 5 degrees below the threshold set. The default | |
|
| |
|
| setting is 72o C. |
System Fan Monitor Submenu | ||
|
| This feature allows you to determine how the system will control the speed of the |
Fan Speed |
| onboard fans. Select WORKSTATION if your system is used as a Workstation. |
| Select SERVER if your system is used as a server. Select Disable to disable the | |
Control |
| fan speed control function to allow the onboard fans to continuously run at full |
|
| speed (12V). The options are 1) Disable (Full Speed) 2) |
|
| |
FAN1 Speed |
| The speeds of the onboard fans (in rpm) are displayed here. |
through FAN4 |
| |
Reading |
|
|
|
| Other items in the submenu are systems monitor displays for the following |
Other |
| information: |
| CPU1 TEMPERATURE, CPU2 TEMPERATURE (for 2U systems), SYSTEM | |
Information |
| TEMPERATURE, VCOREA, VCOREB (for 2U systems), HT VOLTAGE, CPU1 MEM |
|
| VTT, CPU2 MEM VTT, CPU1 MEM, CPU2 MEM, 12V, 3.3V, VDD, 5V VSB, |
|
| MCP55VCORE, 1.5V and VBAT. |
|
|
|
| Table | |
|
| |
Menu Item | Description | |
View BMC System | Use the "+" and | |
Event Log | Enter key will open the following setting: | |
|
| |
Clear BMC | Selecting this and pressing the Enter key will clear the BMC system event log. | |
System Event Log | ||
Set LAN | Use the "+" and | |
Configuration | ||
| ||
|
| |
IP Address | Use the "+" and | |
address in the BMC are shown. | ||
| ||
MAC Address | Use the "+" and | |
MAC address in the BMC are shown. | ||
| ||
|
| |
Subnet Mask | Use the "+" and | |
subnet address in the BMC are shown. | ||
| ||
Set PEF Configuration Submenu | ||
|
| |
PEF Support | Use this setting to ENABLE or Disable PEF support. When enabled, the following | |
settings will appear: | ||
| ||
BMC Watch Dog | This setting is used to set the Watch Dog function. The options are Disabled, | |
Timer Action | RESET SYSTEM, POWER DOWN and POWER CYCLE. | |
|
|