H8DMT/H8DMT-IBX/H8DMT-F/H8DMT-IBXF User’s Manual
Checkpoint | Code Description |
FCh | Next, erasing the flash ROM. |
FDh | Next, programming the flash ROM. |
|
|
FFh | Flash ROM programming was successful. Next, restarting the system BIOS. |
|
|
B-3 Uncompressed Initialization Codes
The following runtime checkpoint codes are listed in order of execution.
These codes are uncompressed in F0000h shadow RAM.
Checkpoint | Code Description | |
03h | The NMI is disabled. Next, checking for a soft reset or a power on condition. | |
|
| |
05h | The BIOS stack has been built. Next, disabling cache memory. | |
06h | Uncompressing the POST code next. | |
|
| |
07h | Next, initializing the CPU and the CPU data area. | |
08h | The CMOS checksum calculation is done next. | |
|
| |
0Ah | The CMOS checksum calculation is done. Initializing the CMOS status register | |
for date and time next. | ||
| ||
0Bh | The CMOS status register is initialized. Next, performing any required | |
initialization before the keyboard BAT command is issued. | ||
| ||
|
| |
0Ch | The keyboard controller input buffer is free. Next, issuing the BAT command to | |
the keyboard controller. | ||
| ||
| The keyboard controller BAT command result has been verified. Next, | |
0Eh | performing any necessary initialization after the keyboard controller BAT | |
| command test. | |
|
| |
0Fh | The initialization after the keyboard controller BAT command test is done. The | |
keyboard command byte is written next. | ||
| ||
10h | The keyboard controller command byte is written. Next, issuing the Pin 23 and | |
24 blocking and unblocking command. | ||
| ||
|
| |
11h | Next, checking if <End or <Ins> keys were pressed during power on. Initializing | |
CMOS RAM if the Initialize CMOS RAM in every boot AMIBIOS POST option | ||
| was set in AMIBCP or the <End> key was pressed. | |
12h | Next, disabling DMA controllers 1 and 2 and interrupt controllers 1 and 2. | |
|
| |
13h | The video display has been disabled. Port B has been initialized. Next, initializing | |
the chipset. | ||
| ||
14h | The 8254 timer test will begin next. | |
|
| |
19h | Next, programming the flash ROM. | |
1Ah | The memory refresh line is toggling. Checking the 15 second on/off time next. | |
|
| |
2Bh | Passing control to the video ROM to perform any required configuration before | |
the video ROM test. | ||
| ||
2Ch | All necessary processing before passing control to the video ROM is done. | |
Looking for the video ROM next and passing control to it. | ||
| ||
|
|