Raymarine S1000 manual Using the hydraulic hoses

Page 9

S1000 Autopilot Installation Guide

7

Using the hydraulic hoses

Three, pre-assembled hydraulic hoses are supplied. Two of these are dark-colored, high pressure steering hoses and the third is a transparent low-pressure hose.

The transparent hose is intended to help you check for air bubbles when bleeding the system and must be used only to connect the autopilot pump reservoir to the lower connector on the helm pump. It must NOT be used anywhere else in the system.

w

rtoP

rt	rtoP
oP

D7553-2

Image 9

Contents Installation Guide S1000 Autopilot System Welcome to the Raymarine S1000 AutopilotInstallation overview Important note This guideParts supplied What you needTools & materials required Locating the course computer PlanningAutopilot pump to be lower than helm pump Locating autopilot pumpUsing the hydraulic hoses Sealing hydraulic joints Installing tapered thread fittingsConnecting the autopilot pump, sheet Connecting the autopilot pump10S1000 Autopilot Installation Guide Now bleed the steering system Bleeding the steering system Bleed procedure, sheetD7339-2 D7337-2 Now secure the pump Securing the pump Securing the pumpSecuring course computer Fitting the course computerSafety alarm Fitting miscellaneous itemsFitting batteries in S100 Remote At fixed position Fitting S100 Remote cradleSecuring In-line power switchSummary Electrical connectionsS1000 Autopilot Grounding Alternative method Diagram a Connecting RF ground preferred methodDiagram B Connecting power & autopilot pump GPS requirement Diagram C Connecting the Data CableUsing with Raymarine GPS Diagram D Nmea connectionsSecure wires Check for leaks sheet Post installationChecking direction of turn sheet Autopilot checks & setupD7705-2 Specifications General Information Suppression Ferrites Raymarine Inc