Furuno FI-504 manual Junction box option

Page 27

3. INSTALLATION

Junction box (option)

The junction box is required when connecting NMEA 2000 network. This section covers wiring of the junction box. For how to mount the junction box, see its installation instructions, issued separately.

12VDC	CN4
CN3	CN4
DROP	DROP

CN5

DROP

BACKBONE

12 VDC

NMEA2000

FI-501/502/503/504/505/506 DEVICE

Fix cable with cable tie (supplied).

CH3 DROP - CH5 DROP and BACKBONE are socket-and-plug-type ter- minal blocks. Detach plug to connect wiring to it, by rocking it back and forth with your fingers. Remove approx. 6 mm of the sheath from the end of wires and twist wires. Loosen fixing screw in the plug, insert wire into hole and tighten fixing screw. Set plug to socket.

Drain wire

White

Red Sheath

Blue

Black

6mm

How to fabricate cable

Fixing screw

Hole for wire

Wire

Twist

How to insert wire

19

Image 27

Contents FI-504 Multi Instrument 00016733410 Important Notices Safety Instructions Table of Contents Word to the Owner of the FI-504 ForewordStandalone configuration System ConfigurationNmea 2000 Sensors Nmea 2000 networkOperating Controls, Display Layout OperationAdjusting Brilliance and Contrast Turning the Power On/OffDepth Selecting a DisplayDisplay description Depth categorySpeed category Wind category Timer categoryNavigation category Heading categoryEnvironment category Autopilot categoryEngine category Selecting Apparent or True Wind Angle, Wind Speed Resetting Counters and IndicationsMAX38.9 LO9.7 12.2 AlarmsAlarm description How to set the timers TimersCount-up timer Count-down timersOperation Preventive Maintenance MAINTENANCE, TroubleshootingTroubleshooting Optional supply InstallationEquipment Lists Standard supplySurface mount 1 Fix instrument from front panel MountingSurface mount 2 Fix instrument from rear panel Multi-instrument configuration WiringJunction box option Sensor FI-50x FI-50x FI-50x Terminal resistorSetup1 menu Setting UpOff OFF SPD RES LOC OFF Setup2 menuSetup2 menu items Press the SELECT/CLEAR Specifications Ｐａｃｋｉｎｇﾌﾗｯｼｭﾏｳﾝﾄｷｯﾄ Jul.2407 R.Esumi Jul.2407 R.Esumi Jul.2407 R.Esumi Instrument タッピンネジ用穴（4ヵ所） For tapping screws 4 pcs