Furuno FI-504 manual Safety Instructions

Page 4

SAFETY INSTRUCTIONS

SAFETY INSTRUCTIONS

The operator of this equipment must read these safety instructions before attempting to operate the equipment.

 

 

WARNING

avoided, could result in death or serious injury.

 

 

 

 

Indicates a potentially hazardous situation which, if not

 

 

 

 

 

 

 

 

CAUTION

Indicates a potentially hazardous situation which, if not

 

 

 

avoided, may result in minor or moderate injury.

 

 

 

 

 

 

 

 

 

Warning, Caution

Prohibitive Action

Mandatory Action

 

 

 

 

 

Safety instructions for the operator

Safety instructions for the installer

 

WARNING

Do not open the equipment.

Only qualified personnel should work inside the equipment.

Do not disassemble or modify the equipment.

Fire or electrical shock can result if the equipment is modified.

Do not operate the equipment with wet hands.

Electrical shock can result.

Make sure no rain or water splash leaks into the equipment.

Fire or electrical shock can result if water leaks into the equipment.

Immediately turn off the power at the switchboard if water leaks into the equipment.

Continued use of the equipment can cause fire or electrical shock.

WARNING

Turn off the power at the switch- board before beginning the installation.

Turn off the power to prevent electrical shock.

Make sure the installation site is not subject to water spray.

Fire or electrical shock can result if water leaks into the equipment.

CAUTION

Observe the following compass safe distances to prevent interfer- ence to the instruments:

 

 

 

Standard

Steering

 

 

 

compass

compass

 

 

 

 

FI-50 series

 

 

0.35 m

0.30 m

Instruments

 

 

Warning Label

A warning label is attached to the equipment. Do not remove the label. If the label is missing or damaged, contact a FURUNO agent or dealer about replacement.

ii

Image 4
Contents FI-504 Multi Instrument 00016733410 Important Notices Safety Instructions Table of Contents Foreword Word to the Owner of the FI-504System Configuration Standalone configurationNmea 2000 network Nmea 2000 SensorsOperation Operating Controls, Display LayoutTurning the Power On/Off Adjusting Brilliance and ContrastSelecting a Display DepthDepth category Display descriptionSpeed category Timer category Wind categoryHeading category Navigation categoryAutopilot category Environment categoryEngine category Resetting Counters and Indications Selecting Apparent or True Wind Angle, Wind SpeedAlarms MAX38.9 LO9.7 12.2Alarm description Timers Count-up timerCount-down timers How to set the timersOperation MAINTENANCE, Troubleshooting Preventive MaintenanceTroubleshooting Installation Equipment ListsStandard supply Optional supplyMounting Surface mount 1 Fix instrument from front panelSurface mount 2 Fix instrument from rear panel Wiring Multi-instrument configurationJunction box option Terminal resistor Sensor FI-50x FI-50x FI-50xSetting Up Setup1 menuOff OFF SPD RES LOC Setup2 menu OFFSetup2 menu items Press the SELECT/CLEAR Specifications Packing フラッシュマウントキット Jul.2407 R.Esumi Jul.2407 R.Esumi Jul.2407 R.Esumi Instrument タッピンネジ用穴(4ヵ所) For tapping screws 4 pcs