Furuno FI-504 manual Press the SELECT/CLEAR

Page 36

3. INSTALLATION

Setup2 menu items

	Display	Function	Setting range or	Default
	Display	Function	options	setting
			options	setting
	TIMER	Turn timer displays on/off.	ON, OFF	ON
	CAL
	ON
	WIND CAL	Turn wind displays on/off.	ON, OFF	ON
	WIND CAL
	ON
	HEADING	Turn heading displays on/off.	ON, OFF	ON
	CAL
	ON
	NAVI CAL	Turn navigation displays	ON, OFF	ON
	NAVI CAL	on/off.
	ON
	ENVIRO	Turn environmental displays	ON, OFF	ON
	CAL	on/off.
	ON
	A PILOT	Turn autopilot displays on/off.	ON, OFF	ON
	CAL
	ON

	ENGINE	Turn engine displays on/off.	ON, OFF	ON
	CAL
	ON

	DEMOCAL	Demo mode. To enable,	ON, OFF	OFF
	DEMOCAL	press the SELECT/CLEAR
	OFF	key. Depth is shown.
		To disable and return to this
		menu, press and hold down
		the SELECT/CLEAR key.
	RESET	Restore factory defaults.
	CAL	To restore factory defaults,
	OFF	press and hold down the
		SELECT/CLEAR key to
		show ON. Press the key
		again. A beep sounds upon
		completion.

28

Image 36

Contents FI-504 Multi Instrument 00016733410 Important Notices Safety Instructions Table of Contents Foreword Word to the Owner of the FI-504System Configuration Standalone configurationNmea 2000 network Nmea 2000 SensorsOperation Operating Controls, Display LayoutTurning the Power On/Off Adjusting Brilliance and ContrastSelecting a Display DepthDisplay description Depth categorySpeed category Timer category Wind categoryHeading category Navigation categoryEnvironment category Autopilot categoryEngine category Resetting Counters and Indications Selecting Apparent or True Wind Angle, Wind SpeedAlarms MAX38.9 LO9.7 12.2Alarm description Timers Count-up timerCount-down timers How to set the timersOperation MAINTENANCE, Troubleshooting Preventive MaintenanceTroubleshooting Installation Equipment ListsStandard supply Optional supplyMounting Surface mount 1 Fix instrument from front panelSurface mount 2 Fix instrument from rear panel Wiring Multi-instrument configurationJunction box option Terminal resistor Sensor FI-50x FI-50x FI-50xSetting Up Setup1 menuOff OFF SPD RES LOC Setup2 menu OFFSetup2 menu items Press the SELECT/CLEAR Specifications Ｐａｃｋｉｎｇﾌﾗｯｼｭﾏｳﾝﾄｷｯﾄ Jul.2407 R.Esumi Jul.2407 R.Esumi Jul.2407 R.Esumi Instrument タッピンネジ用穴（4ヵ所） For tapping screws 4 pcs