Baja Marine 40 manual Lifesaving Equipment

Page 14

Section 1 • Safety

5.Lifesaving Equipment

!WARNING

Have all passengers and the operator wear a Personal Flotation Device (PFD) at all times when boating.

When someone is overboard, it can be too late to have them put on a PFD.

Even strong swimmers can tire quickly in the water and drown due to exhaustion, hypothermia, or both. The buoyancy provided by a personal flotation device (PFD) will allow the person who has fallen overboard to remain afloat with far less effort and heat loss, extending survival time necessary to find and retrieve them.

Boat operators are required to carry one wearable personal flotation device (Type I, II, III or V) for every person on board. Boats must also have at least one throwable device (Type IV).

The law requires that PFDs must be readily accessible, if not worn. "Readily accessible" means removed from storage bags and unbuckled. But, children and non-swimmers must wear PFDs at all times when aboard. It is common sense to have everyone on board wearing PFDs. A throwable device must also be right at hand and ready to toss.

PFD Classifications:

(FIG. 1.4.1)

Off-Shore Life Jacket (Type I) – most

 

buoyant, it is designed to turn an

 

unconscious person face up; used in

 

all types of waters where rescue may

 

be slow, particularly in cold or rough

 

conditions.

(FIG. 1.4.2) Near-Shore Life Vest (Type II) – "keyhole" vest with flotation-filled head and neck support is also designed to turn a person face up, but the turning action is not as pronounced; used in calm, inland waters or where quick rescue is likely.

(FIG. 1.4.3)

Flotation Aid (Type III) – vest is

 

designed so conscious wearers can

 

turn face up; often designed for

 

comfort while engaged in sports such

 

as skiing.

(FIG. 1.4.4)

Throwable Devices (Type IV) –

 

horseshoe buoys, ring buoys and

 

buoyant cushions are designed to be

 

grasped, not worn.

(FIG. 1.4.5)

Special-Use Devices (Type V) –

 

 

sailboat harnesses, white-water

 

vests, float coats, and hybrid vests

 

which have minimum inherent

 

buoyancy and an inflatable

 

chamber.

Before purchasing PFDs, ensure that there is an attached tag indicating they are approved by the U.S. Coast Guard or by your national boating law enforcement agency.

Children and non-swimmers must wear PFDs at all times when aboard.

All passengers and crew should wear them.

A loose PFD is often useless in an emergency.

The operator is responsible for instructing everyone aboard on the location and use of PFDs.

Size PFDs for the wearer. Children require special attention in the use of PFDs.

Test PFD buoyancy at least once a year.

1.4

40 Outlaw®

Image 14
Contents Baja Marine OutlawFor information call 1-865-971-6270 or fax Welcome This page intentionally left blank Introduction Manufacturer’s Certification Service, Parts and Repair for Your BoatHull Identification Number HIN About Your Express Limited Warranty Iii Ignition Protection Breakers and/or Fuses Speed changes you. TM Safety Safety LabelsCarbon Monoxide Legally Mandated Minimum Required EquipmentFire Extinguishing System Carbon Monoxide Monitor Lifesaving Equipment Additional Recommended Equipment for Safe Operation Impaired OperationPropellers Power CapacityLoad Capacity United StatesStability Maintain ControlGeneral Considerations Chart Your CourseWeather Skiing Water SportsSwimming Emergency Situations GeneralFire Medical EmergencyWater Rescue Flooding, Swamping and CapsizingGrounding Safety HotlinesCollisions and Leaking Propulsion, Control or Steering FailureFuel and Oil Spillage International RequirementsEnvironmental Considerations Excessive Noise Waste DisposalWake/Wash Nautical Terms Key to Symbols on Controls & Prints Baja Marine Corp This Page Intentionally Left Blank General Boat Arrangement Docking /Lifting /Trailering Passenger Locations2 Hull Basic Boat Dimensions and Clearances Metric Propulsion SystemGeneral Deck Layout General Deck Layout FIGGear Shift and Throttle Control Power Trim Unit and GaugeDescription of Major Controls Trailer Switch Trim TabsImportant Gauges Ignition Shutdown SwitchEngine Alarm System Tachometer and Hour MeterOil Pressure, Water Temperature, Voltmeter and Fuel Gauges Navigation and Anchor LightsUsing Your Boat Pre-Launch, Launch and Post- Launch ChecklistTrailer Launching and Loading Fueling the BoatBoarding Personal Flotation DevicesPassenger Instruction and Location Starting the EngineShifting to Drive the Boat Stopping the EngineSteering Systems Hydraulic SteeringPower Steering Power Steering SystemThis page intentionally left blank Fuel & Oil Spillage Bilge & Underwater GearBilge Drain PlugBilge Blowers Maintenance and ServiceEngines and Stern Drive Vibration and CausesPropeller Removal and Installation Impact to Stern DriveGear case Anti-Siphon Valve Inboard/Outboard Engine Only Fuel SystemFuel System Static Electricity and the Fuel System Fueling PrecautionsBefore and During Fueling Checklist After Fueling Checklist This page intentionally left blank Direct Current DC Electrical SystemsElectrical Systems BatteriesFuse Panel Electrolytic Corrosion & Zinc AnodesBreakers and/or Fuses Marine Electronic Cathodic Anti-corrosion System Mercathode Ignition Switch Drive Pump with K-Plane Trim Tabs FIG Switch Panel Wire Information Triple FIG Switch Panel Wire Information Twin FIG Wiring Harness Information FIG DC Distribution Wiring Information FIG Hull Wiring Harness Information FIG Gauge Panel Wiring Information FIG Breaker Panel Wiring Information FIG Options & Accessories Options & Accessories LocationsCanvas Automatic Fire Extinguisher System OptionFire Extinguisher Port Depth Finder Optional Canvas Care and MaintenanceSwim Platform w/ Ladder Optional HornPortable Head with Pump-Out Stereo SystemHead Systems Requirements for OperatorsHolding Tank Operation Exhaust SystemsVacuFlush Head Option Vent FilterThis page intentionally left blank Interval Required Inspection, Service MaintenanceSummary Guide for Inspection, Service and Maintenance Summary Guide For Inspection, Service and Maintenance IntervalUseful Service Information Inspection, Service and Maintenance Protocol Bilge AreaTopside and Supplies Winterization Checklist for Boats Stored on LandBatteryies Boat StorageFuel System Fitting Out After StorageFuel Systems MiscellaneousPower Steering System Maintenance Security ConsiderationsBoat Systems Quick Reference ChecklistBoarding the Boat General Starting the Engine Quick Reference Checklist cont’d Departing General Returning to Port GeneralIf the Engine Does Not Start Quick Reference Checklist cont’dSecuring the Boat After Market Equipment Checklist Maintenance Log Maintenance Log Cont’d Stains & Scratches Paint Cleaning Agents & Other SubstancesCare & Refinishing Fiberglass & GelcoatAcrylic Plastic Sheeting Plastic Glass Permanently Moored or Docked BoatsTopside Areas Canvas and Clear VinylExterior Upholstery Fabric Interior Upholstery FabricThis Page Intentionally Left Blank Index Index Outlaw