Baldor BSC 7107 DC manual Limited Warranty

Page 5

Limited Warranty

For a period of one (1) year from the date of original purchase, BALDOR will repair or replace without charge controls and accessories which our examination proves to be defective in material or workmanship. This warranty is valid if the unit has not been tampered with by unauthorized persons, misused, abused, or improperly installed and has been used in accordance with the instructions and/or ratings supplied. This warranty is in lieu of any other warranty or guarantee expressed or implied. BALDOR shall not be held responsible for any expense (including installation and removal), inconvenience, or consequential damage, including injury to any person or property caused by items of our manufacture or sale. (Some states do not allow exclusion or limitation of incidental or consequential damages, so the above exclusion may not apply.) In any event, BALDOR’s total liability, under all circumstances, shall not exceed the full purchase price of the control. Claims for purchase price refunds, repairs, or replacements must be referred to BALDOR with all pertinent data as to the defect, the date purchased, the task performed by the control, and the problem encountered. No liability is assumed for expendable items such as fuses.

Goods may be returned only with written notification including a BALDOR Return Authorization Number and any return shipments must be prepaid.

1-2 General Information

Image 5
Contents MN1231 BSC DC Brushless Control Installation and Operating ManualTable of Contents Ii Table of Contents Introduction Section General InformationLimited Warranty Precautions Safety NoticeBe sure the system is properly grounded before Installation Section Receiving & InstallationControl Installation ReceivingSpeed Potentiometer Refer to Figure AC Power Connection Refer to FigureControl Connection Locations Connect the three motor leads to P1 terminals as follows Sensor and Motor Connections Refer to FigureReverse Operation 1st Time Power Up Procedure or after a motor is replaced Current Limit Adjustment Section AdjustmentsAdjusting Closed Loop Gain Minimum Speed AdjustmentDimensions Section Specifications and DataSpecifications Hall Signal Timing Diagram Box Fort Smith, AR 479 Fax 479