Multiquip jwn24htcsl, jwn24hscsl operation manual MODELs Jwn24htcsl Jwn24hscsl

Page 1

Operation Manual

SERIES

MODELs

jwn24htcsl

jwn24hscsl

ride-on power trowels

(HONDA GX690RTAF GASOLINE ENGINE)

STARTING S/N VB0206952

Revision #1 (05/12/12)

To find the latest revision of this publication, visit our website at: www.multiquip.com

THIS MANUAL MUST ACCOMPANY THE EQUIPMENT AT ALL TIMES.

PN: 23624

Image 1
Contents MODELs Jwn24htcsl Jwn24hscsl Proposition 65 Warning Silicosis Warning Silicosis/Respiratory WarningsSpecifications are subject to change without notice Table of ContentsCompletely Training ChecklistDaily pre-Operation Checklist Daily pre-operation checklistSaFeTy meSSageS Safety InformationGeNeRaL SaFeTy ENgINe SaFeTy TROWeL SaFeTy„ NeveR tamper with the factory settings Order Form PT-160BaTTeRy SaFeTy FueL SaFeTyTRaNSpORTINg SaFeTy „ Use well-insulated gloves when picking up the battery„ aLWayS shutdown engine before transporting TOWINg SaFeTyEmISSIONS INFORmaTION ENvIRONmeNTaL SaFeTyEmission Control Label Label must remain with the engine for its entire lifeTrowel Specifications Specifications/dimensionsWhole Body Vibration Per ISO 2631-11997 +A12010 M/s 2 ∑A8 Sound Power Level in dBAGeneral information Components Front ComponentsComponents Rear Muffler Used to reduce noise and emissions Basic engineFuel Filter Filters fuel for contaminants Seat Assembly Control Handle AssemblyBattery Setup Set-upEngine Oil Level InspectionGearbox Oil Level FuelImportant Information Before You Start OperationStarting the Engine Forward Direction Maintenance Oil Filter 200 Hours Changing Engine Oil 100 HoursFuel Filter 200 Hours Oil And Fuel LinesBelt Guard Removal Checking The Drive BeltSpare Belt Removal SPARE Drive Belt Removal Using Replacement Drive BeltReinstall belt guard assembly Starting The Trowel/TestingPlace spare drive belt onto clutch as shown in Figure Engine’s exhaust contains harmful emissionsHow it works CV-joint Assembly installation left-sideSingle Pitch Blade PitchTwin PitchTM Changing Blades Blade Pitch Adjustment Procedure„„Do the pitch control towers rock back and forth? Trowel Arm Adjustment Procedure Clean-UpTrowel Blade Removal Trowel Arm RemovalRemove the trowel arm from the spider plate Checking Trowel Arm Straightness Trowel Arm AdjustmentTrowel Arm Adjustment Fixture Components ReassemblyDecommissioning Trowel/Components Installing Pans Onto Finisher BladesLifting/Crush Hazard. do not lift trowel with pans attached Block Wiring diagramCombination Switch Continuity REF. Connector Function DES Wiring diagram component locatorTroubleshooting engine TroubleshootingAir cleaner dirty? Clean or replace air cleaner Troubleshooting Ride-On mechanical Trowel Wiring? Page HERE’S HOW to GET Help