Multiquip jwn24hscsl SPARE Drive Belt Removal Using Replacement Drive Belt, Spare Belt Removal

Page 26

maintenance

sPARE Drive Belt REMOVAL (Using Replacement Drive Belt)

The JWN-SERIES Ride-On Power Trowel is equipped with a replacement drive belt (spare) carrier, which is mounted on the inboard side of the left-side gearbox . Make sure that there is ALWAYS a spare drive belt in the drive belt carrier before the trowel is placed on a slab to finish concrete.

In the event of a drive belt failure, the spare (replacement) drive belt can be used for quick replacement at the job site for continued trowel operation.

1.To replace an existing drive belt with the spare drive belt, remove the 2 bolts that secure the spare belt holder to the left-side gearbox adapter plate. (Figure 17) Take care not to contaminate the replacement drive belt with grease or dirt.

REMOVE

SPARE DRIVE 2 PLACES

BELT HOLDER

SPARE

DRIVE BELT

REMOVE

LEFT-SIDE

GEARBOX

ADAPTER PLATE

Figure 17. Spare Belt Removal

2.Remove existing drive belt from clutch and lower drive pulley, by cutting belt.

3.Ensure all remnants of old drive belt have been removed from the sheaves/grooves of the clutch and lower pulley

4.Slide spare drive belt over the CV-joint (Figure 18) an onto the lower drive pulley.

SPARE

DRIVE BELT

LOWER DRIVE

PULLEY

CV-JOINT

Figure 18. Spare Drive Belt Routing

5.Next, squeeze the drive belt (Figure 19) and pull upwards and towards the rear of the trowel. This will spread open the faces of the lower drive pulley.

PULL UPWARDS
AND TOWARDS	DRIVE BELT
REAR OF TROWEL

LOWER

PULLEY

Figure 19. Spare Drive Belt Placement

(Lower Pulley)

page 26 — JWN-SERIES RIDE-ON POWER TROWEL • operation manual — rev. #1 (05/12/12)

Image 26

Contents MODELs Jwn24htcsl Jwn24hscsl Proposition 65 Warning Silicosis/Respiratory Warnings Silicosis WarningTable of Contents Specifications are subject to change without noticeTraining Checklist CompletelyDaily pre-operation checklist Daily pre-Operation ChecklistSafety Information SaFeTy meSSageSGeNeRaL SaFeTy „ NeveR tamper with the factory settings TROWeL SaFeTyENgINe SaFeTy Order Form PT-160TRaNSpORTINg SaFeTy FueL SaFeTyBaTTeRy SaFeTy „ Use well-insulated gloves when picking up the batteryTOWINg SaFeTy „ aLWayS shutdown engine before transportingEmission Control Label ENvIRONmeNTaL SaFeTyEmISSIONS INFORmaTION Label must remain with the engine for its entire lifeSpecifications/dimensions Trowel SpecificationsSound Power Level in dBA Whole Body Vibration Per ISO 2631-11997 +A12010 M/s 2 ∑A8General information Components Components FrontComponents Rear Fuel Filter Filters fuel for contaminants Basic engineMuffler Used to reduce noise and emissions Battery Setup Control Handle AssemblySeat Assembly Set-upGearbox Oil Level InspectionEngine Oil Level FuelStarting the Engine OperationImportant Information Before You Start Forward Direction Maintenance Fuel Filter 200 Hours Changing Engine Oil 100 HoursOil Filter 200 Hours Oil And Fuel LinesChecking The Drive Belt Belt Guard RemovalSPARE Drive Belt Removal Using Replacement Drive Belt Spare Belt RemovalPlace spare drive belt onto clutch as shown in Figure Starting The Trowel/TestingReinstall belt guard assembly Engine’s exhaust contains harmful emissionsCV-joint Assembly installation left-side How it worksTwin PitchTM Blade PitchSingle Pitch „„Do the pitch control towers rock back and forth? Blade Pitch Adjustment ProcedureChanging Blades Clean-Up Trowel Arm Adjustment ProcedureRemove the trowel arm from the spider plate Trowel Arm RemovalTrowel Blade Removal Trowel Arm Adjustment Checking Trowel Arm StraightnessReassembly Trowel Arm Adjustment Fixture ComponentsLifting/Crush Hazard. do not lift trowel with pans attached Installing Pans Onto Finisher BladesDecommissioning Trowel/Components Wiring diagram BlockCombination Switch Continuity Wiring diagram component locator REF. Connector Function DESTroubleshooting Troubleshooting engineAir cleaner dirty? Clean or replace air cleaner Troubleshooting Ride-On mechanical Trowel Wiring? Page HERE’S HOW to GET Help