Cisco Systems 3110G, 3110X, 3012 manual Removing a Module, Installing an X2 Transceiver Module

Chapter 2 Switch Module Installation

Installing Devices in the 10-Gigabit Ethernet Slot

Caution Verify the correct orientation of your module before inserting it into the slot. Incorrect insertion can damage the module.

Step 5 Slide the transceiver module into the opening until the back of the module faceplate is flush with the switch module faceplate.

Figure 2-7 Installing an X2 Transceiver Module

C O N S O L M EO D E

!
M	M
B
R	S
	T

X2

1 STACK 2

201899

Removing a Module

To remove an X2 transceiver module, follow these steps:

Step 1 Attach an ESD-preventive wrist strap to your wrist and to a bare metal surface.

Step 2 Disconnect the cables from the module. For fiber-optic modules, install the optical bore dust plugs.

Step 3 Carefully pull on the X2 module sleeve to disengage it from the slot. Grasp the edges of the module, and carefully slide it out of the slot.

Step 4 Reinstall a replacement module or the module slot cover in the 10-Gigabit Ethernet slot. Step 5 Place the module in an antistatic bag or other protective environment.

	Catalyst Switch Module 3110G, 3110X, and 3012 for IBM BladeCenter Hardware Installation Guide
2-12	OL-12192-01