Cisco Systems 3110X, 3110G, 3012 manual Switch Stack Cabling Examples

Page 24

Chapter 2 Switch Module Installation

Creating Switch Stacks

Switch Stack Cabling Examples

Figure 2-4is an example of a recommended configuration in which two switch modules create a switch stack in a single blade enclosure.

Figure 2-4 Stacking Switch Modules in a Single Blade Enclosure to Create One Stack

203294

Catalyst Switch Module 3110G, 3110X, and 3012 for IBM BladeCenter Hardware Installation Guide

2-8	OL-12192-01

Image 24

Contents Americas Headquarters Text Part Number OL-12192-01Page N T E N T S Diagnosing Problems Preface AudiencePurpose ConventionsRelated Publications Switch Modules Switch ModelProduct Overview IBM Part Number DescriptionHardware Features WS-CBS3012-IBM WS-CBS3012-IBM-ICatalyst Switch Module 10/100/1000 Ethernet PortsGigabit Ethernet Module Slot Port NumberingInternal 100BASE-T Ethernet Management Port Port DescriptionSwitch Module LEDs Switch Module LEDs and Mode ButtonMode Button System Power LEDStack Master LED Color System StatusFault/Stack Mode LED Fault LEDStack Member LED Port LEDs Color Activity LED Description Link Status LED DescriptionColor LED Description Management Options StackWise Plus PortsConsole Port Port Status LED DescriptionNetwork Configurations Switch Module Installation Preparing for InstallationSafety Warnings OL-12192-01 Installation Guidelines Box ContentsInstalling the Switch Module Blade Enclosure Rear-Panel ViewAfter Installing the Switch Module Installing the Switch ModuleCreating Switch Stacks Stacking GuidelinesConnecting a Switch Stack Connecting the StackWise Plus CablesSwitch Stack Cabling Examples 203295 203296 Installing Devices in the 10-Gigabit Ethernet Slot Installing an X2 Transceiver ModuleInstalling an X2 Transceiver Module Removing a ModuleConnecting Devices to the Ethernet Ports Where to Go NextDevice Crossover Cable OL-12192-01 Troubleshooting Diagnosing ProblemsVerify Switch Module Post Results Verify Switch Module LEDsVerify Switch Module Connections Bad or Damaged CableEthernet and Fiber Cables Link StatusTransceiver Issues Port and Interface SettingsPing End Device Spanning Tree LoopsResetting the Switch Module Verify Switch Module PerformanceSpeed, Duplex, and Autonegotiation Autonegotiation and Network Interface CardsHow to Replace a Failed Stack Member Using the Mode Button to Reset the Switch ModuleOL-12192-01 Technical Specifications Physical SpecificationsPower Specifications Environmental RangesOL-12192-01 Connector and Cable Specifications Connector Specifications10/100/1000 Ports Cable and Adapter Specifications Gigabit Ethernet Module InterfaceGigabit Ethernet X2 Transceiver Module Cable Specifications Four Twisted-Pair Straight-Through Cable Schematic Four Twisted-Pair Cable PinoutsTwo Twisted-Pair Cable Pinouts Identifying a Crossover CableOL-12192-01 Numerics IN-2 IN-3 IN-4