EMC 69001166 System or to SP ports Guide, Logged in to the switch port, Zones, HP-UX command

			HP-UX Installation Checklist
Task		With Access Logix		Reference Document
12	Server	❑ Cable any additional HBA ports to the switch connected to the storage		Storage-system setup
	Cable additional	system or to SP ports.		guide
	HBAs to switches	❑ Checkpoint - For a SAN, verify the HBA connections to the switch by
	or storage system
		checking the LED(s) for the switch port connected to each additional HBA
		port.
		For a 1-Gbit switch - LED is green, which indicates that the HBA port is
		logged in to the switch port.
		For a 2-Gbit switch - One of the following:
		• The left LED is green and the right LED is off, which indicates that a
		1-Gbit SP port is logged in to the switch port.
		• For a DS-xxB2 switch, both LEDs are green, which indicates that a
		2-Gbit HBA port is logged in to the switch port.
		• For a DS-xxM2 switch, the left LED is blue and the right LED is off, which
		indicates that a 2-Gbit HBA port is logged in to the switch port.
13	Switches	For a SAN		Switch management
	Zone	❑ Zone the switches to provide a path from each additional HBA port (host		documentation
		initiator) to the SPs.
		❑ If SAN Copy, MIrrorView, or MirrorView/A is installed, create any required
		zones.
		❑ Checkpoint - Use switch management software to verify the switch
		connections to the storage system.
14	Server	❑ Make sure that each HBA sees only the targets (SPs) to which it is zoned		HP-UX documentation
	Make target SPs	with the following HP-UX commands:
	available	ioscan -fnC disk
		insf -e
		❑ Verify that HP-UX sees device entries for all LUNS with the following
		HP-UX command:
		ioscan -fnC disk
		❑ Log in as root and restart the Navisphere Host Agent with the following		CX-Series Server
		HP-UX commands:		Software for HP-UX
		/sbin/init.d/agent stop		Installation Guide
		/sbin/init.d/agent start
		❑ Make sure again that each HBA sees only the targets (SPs) to which it is		HP-UX documentation
		zoned with the following HP-UX commands:
		ioscan -fnC disk
		insf -e

PowerPath Checklist - Existing HP-UX Server and New Storage System

2-29