EMC 69001166 manual CX-Series or, Open, use the following Go to step

Windows Installation Checklists

Task	With Access Logix	Without Access Logix	Reference Document
13 CX-Series or	❑ Use Navisphere Manager’s	❑ Use the following Navisphere CLI	Navisphere Manager
FC4700-Series	Failover Setup Wizard (selected	command to determine the	administrator’s guide
Storage System	from the Tools menu on the	default storage-system type:	and online help or
Set properties for	toolbar) to set the following	navicli -h hostname systemtype	Navisphere CLI
	storage-system properties for the		reference
PowerPath
	server’s HBA or NIC ports	where hostname is the IP
	(initiators):	address or network name of an
	Initiator Type to CLARiiON Open	SP in the storage system.
		If the default storage-system
	Failover mode to 1
		system type is not 3 (CLARiiON
	Array commpath to Enabled
		Open), use the following
	Go to step 15.	Navisphere CLI command to set
		it to 3:
		navicli -h hostname systemtype
		-config 3
		CAUTION The above command
		reboots both SPs at the same
		time.
		❑ Use the following Navisphere CLI	Navisphere CLI
		commands to set the default	reference
		failover mode and array
		commpath properties to the
		values for PowerPath:
		navicli -h hostname
		failovermode 1
		navicli -h hostname
		arraycommpath 1
		where hostname is the IP
		address or network name of an
		SP in the storage system.
		Go to step 15.

PowerPath Checklist — New Windows Server and Existing Storage System Without Boot Disk

7-19