EMC 69001166 manual Install HBAs

HP-UX Installation Checklist

Without EMC Failover Software Checklist - New HP-UX Server and New Storage System

Complete the tasks highlighted with grey in the checklist before the service provider arrives.

Task		With Access Logix	Reference Document
1	Server	❑ Install the HBAs.	HBA documentation
	Install HBAs,	❑ Connect a cable from each host HBA port to a switch port or an SP port.
	drivers, cables
		❑ Install the HBA driver.
2	Server	❑ Set the HBA driver parameters to the values required for CLARiiON.	Host connectivity guide
	Set HBA driver		and HBA
			documentation
	parameters
		❑ Reboot the server to complete the installation of the drivers.
		❑ Checkpoint — For a SAN, verify the server connections to the switch by	Switch documentation
		checking the LED(s) for the switch port connected to each HBA port.
		For a 1-Gbit switch - LED is green, which indicates that the HBA is logged
		in to the switch port.
		For a 2-Gbit switch - One of the following:
		• The left LED is green and the right LED is off, which indicates that a
		1-Gbit SP port is logged in to the switch port.
		• For a DS-xxB2 switch, both LEDs are green, which indicates that a
		2-Gbit HBA port is logged in to the switch port.
		• For a DS-xxM2 switch, the left LED is blue and the right LED is off, which
		indicates that a 2-Gbit HBA port is logged in to the switch port.
3	Switches	For a SAN	Switch management
	Zone	❑ Zone the switches to provide a path from each host initiator to an SP.	documentation
4	Server	❑ Make sure each HBA sees only the targets (SPs) to which it is zoned with	HP-UX documentation
	Make target SPs	the following HP-UX commands:
	available	ioscan -fnC disk
		insf -e
		❑ Checkpoint - Reverify that HP-UX sees device entries for all LUNS with
		the following HP-UX command:
		ioscan -fnC disk

Without EMC Failover Software Checklist - New HP-UX Server and New Storage System

2-55