EMC 69001166 manual Reconnect the cable that you, If you did not follow the above

NetWare Installation Checklists

Task	With Access Logix	Without Access Logix	Reference Document
17 Server	❑ Identify the HBA sending I/O to	❑ Identify the HBA sending I/O to	PowerPath product
Test PowerPath	LUN by viewing the output of the	LUN by viewing the output of the	guide
	powermt display dev=x every=2	powermt display dev=x every=2
with a license
	command, and disconnect the	command, and disconnect the
key (cont.)
	cable to that HBA.	cable to that HBA.
	❑ View the output of the powermt	❑ View the output of the powermt
	display dev=x every=2	display dev=x every=2 command,
	command, and verify that	and verify that
	• The state of the uncabled	• The state of the uncabled
	path(s) becomes “dead.”	path(s) becomes “dead.”
	• I/O continues to the remaining	• I/O continues to the remaining
	path(s) to the LUN, indicating	path(s) to the LUN, indicating
	that the path failover was	that the path failover was
	successful, and PowerPath is	successful, and PowerPath is
	working properly.	working properly.
	❑ Reconnect the cable that you	❑ Reconnect the cable that you
	disconnected from the HBA.	disconnected from the HBA.
	❑ If you did not follow the above	❑ If you did not follow the above
	steps exactly and caused any	steps exactly and caused any
	LUNs to trespass, restore the	LUNs to trespass, restore the
	LUNs to their original SP with the	LUNs to their original SP with the
	following PowerPath command:	following PowerPath command:
	powermt restore	powermt restore

4-38

EMC Installation Roadmap for CX-Series and FC-Series Storage Systems