EMC 69001166 manual Set up security

			HP-UX Installation Checklist
Task		With Access Logix		Reference Document
9	Storage System	❑ Connect the storage system to the switch or HBA ports.		Storage-system setup
	Cable to switch or	❑ Checkpoint - For a SAN, verify the storage-system connections to the		guide
	server and LAN
		switch by checking the LED(s) for the switch port connected to each SP
		port.
		For a 1-Gbit switch - LED is green, which indicates that the SP is logged in
		to the switch port
		For a 2-Gbit switch - One of the following:
		• The left LED is green and the right LED is off, which indicates that a
		1-Gbit SP port is logged in to the switch port.
		• For a DS-xxB2 switch, both LEDs are green, which indicates that a
		2-Gbit HBA port is logged in to the switch port.
		• For a DS-xxM2 switch, the left LED is blue and the right LED is off, which
		indicates that a 2-Gbit HBA port is logged in to the switch port.
		❑ Cable each SP to the LAN connected to the hosts from which you will		Storage-system setup
		manage the storage system.		guide
10	Storage System	❑ Use Navisphere Manager to define a global administrator and domain (if		Navisphere security
	Set up security	not already defined) and any additional users.		administrator’s guide
				and Navisphere
				Manager online help
11	Storage System	❑ Use the following Navisphere CLI commands to set the storage-system		Navisphere CLI
	Set properties for	properties:		reference
	PowerPath	navicli -h hostname failovermode 1
		navicli -h hostname arraycommpath 1
		where hostname is the IP address or network name of an SP in the storage
		system.
12	Switches	For a SAN		Switch management
	Zone	❑ Zone the switches to provide a path from each host initiator to an SP.		documentation
		❑ Checkpoint - Use switch management software to verify the switch
		connections to the storage system.
13	Server	❑ Make sure that each HBA sees only the targets (SPs) to which it is zoned		HP-UX documentation
	Make target SPs	with the following HP-UX commands:
	available	ioscan -fnC disk
		insf -e
		❑ Verify that HP-UX sees device entries for all LUNS with the following
		HP-UX command:
		ioscan -fnC disk

PowerPath Checklist - New HP-UX Server and New Storage System

2-9