EMC 69001166 manual Make sure the SCSISAN.CDM module is not installed, Unavailable for I/O

NetWare Installation Checklists

PowerPath Checklist — New NetWare Server and New Storage System

Tasks highlighted with grey in the checklist should be completed before the service provider arrives.

Task		With Access Logix		Reference Document
1	Server	❑	Install HBAs.	HBA documentation
	Install HBAs and		CAUTION Do not connect cables to the HBAs until you are told to do so	(see URL on page 4-4)
	driver		later in this procedure.
		❑ Verify HBA BIOS settings.
		❑	Install HBA driver.
2	Server	❑ Set the HBA driver parameters to the values required for CLARiiON and		Host connectivity guide
	Set HBA driver		PowerPath.	and HBA documentation
				(see URL on page 4-4)
	parameters		CAUTION Using improper settings can cause erratic failover behavior,
			such as greatly increased I/O delays.
3	Server	❑ Make sure the SCSISAN.CDM module is not installed.		NetWare documentation
	Install PowerPath	❑	Install PowerPath.	PowerPath release
			Note After PowerPath is installed on a NetWare 6 server, a device named	notes and PowerPath for
				NetWare installation and
			EMC PowerPath Control Device appears under ConsoleOne > Tools >	administrator’s guide
			Disk Management > Devices.This device is always inactive and is
				PowerPath product
			unavailable for I/O.
				guide
			CAUTION If you use the server -nscommand to bring up NetWare, you	PowerPath product
			must either load the PowerPath driver manually or remove all redundant	guide
			paths. Failure to do so may result in LUN corruption.
		❑ Install any PowerPath patches from the Software downloads page on the
			EMC Powerlink website:
			http://powerlink.emc.com
4	Server	❑ Install the Navisphere Host Agent or Navisphere Server Utility and the		CX-Series Server
	Install Host		Navisphere CLI.	Software for NetWare
				Installation Guide
	Agent or Server
	Utility
5	Server	❑ If the server will be a SnapView production or secondary host, install the
	Install admsnap		admsnap utility.

PowerPath Checklist — New NetWare Server and New Storage System

4-7