EMC 69001166 manual Default storage-system, Other cases Where hostname is the IP

			Solaris Installation Checklists
Task	With Access Logix	Without Access Logix		Reference Document
6 CX300, CX400,	❑ Use the following Navisphere CLI	❑ Use the following Navisphere CLI		Navisphere CLI
CX500, CX600,	commands to set the following	commands to set the following		reference
CX700,or	default storage-system	default storage-system
FC4700-Series	properties:	properties:
Storage System	navicli -h hostname	navicli -h hostname
Set properties for
	failovermode 1	failovermode 1
PowerPath (cont.)	navicli -h hostname	navicli -h hostname
	arraycommpath 1	arraycommpath 1
	navicli -h hostname	navicli -h hostname
	unitserialnumber lun (only for	unitserialnumber lun (only for
	server in a Sun Cluster; it must	server in a Sun Cluster; it must
	left at the default setting for all	left at the default setting for all
	other cases)	other cases)
	where hostname is the IP	where hostname is the IP
	address or network name of an	address or network name of an
	SP in the storage system.	SP in the storage system.
	Go to step 8.	Go to step 8.
	For existing HBAs			Navisphere Manager
	An existing HBA is one that is			administrator’s guide
				and online help
	registered with the storage system.
	❑ Use Navisphere Manager’s
	Failover Setup Wizard (selected
	from the Tools menu on the
	toolbar) to set the following
	storage-system properties for the
	server’s existing HBA ports
	(initiators):
	Initiator Type to CLARiiON Open
	Failover mode to 1
	Array commpath to Enabled
	Unit Serial Number to LUN
	Go to step 8.

PowerPath Checklist — Existing Solaris Server and Existing Storage System

5-35