EMC 69001166 manual Use the pkgadd command to add Volume Manager and DMP to

Solaris Installation Checklists

Task		With Access Logix	Reference Document
13	Server	❑ Use the pkgadd command to add Volume Manager and DMP to the	VERITAS Volume
	Install Volume	server.	Manager documentation
	Manager and	❑ Install any recommended VERITAS updates.
	DMP
14	Server	❑ Download the CLARiiON DMP driver to the server from Services on the
	Install the	VERITAS website.
	CLARiiON DMP	❑ Use the pkgadd command to install the CLARiiON DMP driver on the	VERITAS Volume
	driver	server.	Manager documentation
		Note Until rootdg is created (part of vxinstall command) on at least one
		disk, DMP displays an error message looking for the config daemon.
15	Storage System	❑ Use the following Navisphere CLI commands to set the default	navicli man page or
	Set the system	storage-system type and failover mode properties with the following	Navisphere CLI reference
		commands:
	type and failover
	mode	navicli -h sp systemtype -config 3
		navicli -h sp storagegroup -sethost -host solaris_host -failovermode
		2
		where
		sp is the IP address or network name of the SP in the storage system.
		solaris_host is the name of the Solaris server.
16	Server	❑ Reboot the server using the reboot ---rcommand
	Reboot	• to make LUNs available to Solaris
		• to make LUNs accessible via both SPs
		Important If you do not set the failover mode to 2, you will only see half of the
		expected paths to the SPs.
17	Server	❑ Run vxinstall to configure Volume Manager and place at least one LUN	VERITAS Volume
	Configure	under VxVM control	Manager documentation
	Volume Manager
18	Server	For VXVM 3.5 or higher	VERITAS Volume
	Verify DMP	❑ Log into VERITAS Enterprise Administrator (VEA).	Manager documentation
	installation
		❑ Click the host name for the server.
		❑ Click disks.
		❑ Click a device that you know belongs to the CLARiiON storage system.

5-50

EMC Installation Roadmap for CX-Series and FC-Series Storage Systems