EMC 69001166 manual Task With Access Logix, Disconnect the path to that SP

Solaris Installation Checklists

Task	With Access Logix	Reference Document
19 Server	❑ Determine the controller through which I/O is going with	VERITAS Volume
Verify DMP	iostat -xn	Manager documentation
Operation
(cont.)	❑ Determine the HBA and SP to which that controller corresponds.
	❑ Disconnect the path to that SP.
	❑ Verify that the path to the chosen CLARiiON device is disabled with
	vxdisk list device
	or
	vxdmpadm getsubpaths
	dmpnodename=device
	where device is the name of the CLARiiON device
	❑ Verify that I/0 is still running with
	iostat -xn

You are now ready to set up any optional software, such as SnapView or MirrorView, on the storage system.

!CAUTION

If you want to install any new software or upgrade any existing software on a storage system after DMP is installed and running, you should use the Navisphere Manager Software Installation Wizard. If this wizard is not supported for your storage system, be sure to refer to the "Special NDU Procedure" in the "VERITAS Volume Manager" section for CLARiiON of the Host Connectivity Guide for Sun Solaris, which is available on the EMC Powerlink website.

5-52

EMC Installation Roadmap for CX-Series and FC-Series Storage Systems