EMC 69001166 manual For new HBAs For any HBAs

NetWare Installation Checklists

Task		With Access Logix	Without Access Logix	Reference Document
5	Server	❑ Make sure the HBA driver	❑ Make sure the HBA driver	Host connectivity guide
	Set HBA driver	parameters are set to the values	parameters are set to the values	and HBA
		required for CLARiiON and	required for CLARiiON and	documentation (see
	parameters
		PowerPath.	PowerPath.	URL on page 4-4)
		CAUTION Using improper	CAUTION Using improper settings
		settings can cause erratic failover	can cause erratic failover behavior,
		behavior, such as greatly	such as greatly increased I/O
		increased I/O delays.	delays.
6	Storage System	❑ If currently installed	❑ If currently installed	Navisphere Manager
	Update software	storage-system software is not at	storage-system software is not at	administrator’s guide
		the required minimum revision	the required minimum revision (see	and online help
		(see page 4-3), update it.	page 4-3), update it.
		CAUTION During the software	CAUTION During the software
		update, hosts connected to the	update, hosts connected to the
		storage system will lose access	storage system will lose access to
		to data if they do not have failover	data if they do not have failover
		software or if all paths to an SP	software or if all paths to an SP are
		are down.	down.
		For an FC4500 storage system, go to	For an FC4500 storage system, go to
		step 8.	step 8.
7	CX200, CX300,	For new HBAs	For any HBAs	Navisphere CLI
	CX400, CX500,	❑ Use the following Navisphere CLI	❑ Use the following Navisphere CLI	reference
	CX600, CX700,
	or FC4700-Series	command to determine the	command to determine the default
		default storage-system type:	storage-system type:
	Storage System
		navicli -h hostname systemtype	navicli -h hostname systemtype
	Set properties for
	PowerPath	where hostname is the IP	where hostname is the IP address
		address or network name of an	or network name of an SP in the
		SP in the storage system.	storage system.
		If the default storage-system	If the default storage-system
		system type is not 3 (CLARiiON	system type is not 3 (CLARiiON
		Open), use the following	Open), use the following
		Navisphere CLI command to set	Navisphere CLI command to set it
		it to 3:	to 3:
		navicli -h hostname systemtype	navicli -h hostname systemtype
		-config 3	-config 3
		CAUTION The above command	CAUTION The above command
		reboots both SPs at the same	reboots both SPs at the same time.
		time.

4-30

EMC Installation Roadmap for CX-Series and FC-Series Storage Systems