EMC 69001166 11 FC4500 Storage, System Port on the storage system, Lun only for server in a Sun

			Solaris Installation Checklists
Task	With Access Logix	Without Access Logix		Reference Document
11 FC4500 Storage	❑ Connect a computer to the serial	❑ Connect a computer to the serial		Storage-system setup
System	port on the storage system.	port on the storage system		guide
	❑ From the computer connected to	❑ From the computer connected to		Navisphere CLI
	the storage system’s serial port,	the storage system’s serial port,		reference
	use the following Navisphere CLI	use the following Navisphere CLI
	commands to set the following	commands to determine the
	storage-system properties for the	default storage-system type:
	server’s HBA ports (initiators):	navicli -np -d device
	navicli -np -d device	systemtype
	storagegroup -sethost -host	where device is the name of the
	servername -type 3
		computer port connected to the
	navicli -np -d device
		storage-system serial port (for
	storagegroup -sethost -host	example, com1).
	servername -failovermode 1	If the default storage-system
	navicli -np -d device	system type is not 3 (CLARiiON
	storagegroup -sethost -host	Open), use the following
	servername -arraycommpath 1	command to set it to 3:
	navicli -np -d device	navicli -np -d device
	storagegroup -sethost -host	systemtype -config 3
	servername -unitserialnumber	CAUTION The above command
	lun (only for server in a Sun
		reboots both SPs at the same
	Cluster; it must left at the default
		time.
	setting for all other cases)
	where
	device is the name of the
	computer port connected to the
	storage-system serial port (for
	example, com1).
	servername is the name of the
	server with the HBAs.

PowerPath Checklist — New Solaris Server and Existing Storage System

5-19