EMC 69001166 From the Tools menu on, Command to set Storage-system properties, Property to lun

Solaris Installation Checklists

Task	With Access Logix	Without Access Logix	Reference Document
10 CX300, CX400,	❑ Use Navisphere Manager’s	❑ Use the following Navisphere CLI	Navisphere Manager
CX500, CX600,	Failover Setup Wizard (selected	command to determine the	administrator’s guide
CX700, or	from the Tools menu on the	default storage-system type:	and online help or
FC4700-Series	toolbar) to set the following	navicli -h hostname systemtype	Navisphere CLI
Storage System	storage-system properties for the	where hostname is the IP	reference
Set Properties	server’s HBA ports (initiators):
		address or network name of an
for PowerPath	Initiator Type to CLARiiON Open
		SP in the storage system.
	Failover mode to 1
		If the default storage-system
	Array commpath to Enabled
		system type is not 3 (CLARiiON
		Open), use the following
		Navisphere CLI command to set it
		to 3:
		navicli -h hostname systemtype
		-config 3
		where hostname is the IP
		address or network name of an
		SP in the storage system.
		CAUTION The above command
		reboots both SPs at the same
		time.
	❑ If the server is in a Sun Cluster,	❑ Use the following Navisphere CLI	Navisphere CLI
	use the following Navisphere CLI	commands to set the following	reference
	command to set the	storage-system properties:
	unitserialnumber storage-system	navicli -h hostname
	property to lun:
		failovermode 1
	navicli -h hostname
		navicli -h hostname
	unitserialnumber lun
		arraycommpath 1
	where hostname is the IP
		navicli -h hostname
	address or network name of an
		unitserialnumber lun (only for
	SP in the storage system.
		server in a Sun Cluster)
	Go to step 12.
		where hostname is the IP
		address or network name of an
		SP in the storage system.
		Go to step 12.

5-18

EMC Installation Roadmap for CX-Series and FC-Series Storage Systems