EMC 69001166 manual Reboot

HP-UX Installation Checklist

Task		With Access Logix	Reference Document
10	Server	❑ Log in as root and restart the Navisphere Host Agent with the following	CX-Series Server
	Make LUNs	HP-UX commands:	Software for HP-UX
			Installation Guide
	visible	/sbin/init.d/agent stop
		/sbin/init.d/agent start
		❑ Checkpoint - Verify that HP-UX can recognize these LUNs with the	HP-UX documentation
		following HP-UX commands:
		ioscan -fnC disk
		insf -e
		If HP-UX does not recognize any LUNs, verify the connection to the
		Storage Group.
		❑ Checkpoint - Reverify that HP-UX sees device entries for all LUNS with
		the following HP-UX command:
		ioscan -fnC disk
11	Storage System	❑ Plan your monitoring configuration.	Navisphere Manager
	Set up Event	❑ Use Navisphere Manager to set user options, create templates, and set up	administrator’s guide
			and online help
	Monitor
		your monitoring configuration.
12	Server	❑ Download the CLARiiON DMP driver to the server from Services on the
	Install the	VERITAS website.
	CLARiiON DMP	❑ Use the swinstall command to install the CLARiiON DMP driver on the	VERITAS Volume
	driver	server.	Navisphere Manager
		Note Until rootdg is created (part of vxinstall command) on at least one	documentation
		disk, DMP displays an error message looking for the config daemon.
13	Server	❑ Reboot the server using the reboot command	VERITAS Volume
	Reboot	• to make LUNs available to the OS	Navisphere Manager
			documentation
		• to make LUNs accessible via both SPs
		Important If you do not set the failover mode to 2, you will see only half of the
		expected paths to the SPs.
14	Server	❑ Run vxinstall to configure Volume Manager and place at least one LUN	VERITAS Volume
	Configure	under VxVM control.	Navisphere Manager
			documentation
	Volume Manager

2-50

EMC Installation Roadmap for CX-Series and FC-Series Storage Systems