EMC 69001166 manual Install HBAs, Port is logged in to the switch port Storage System

Tru64 UNIX Installation Checklist

Checklist - New Tru64 UNIX Server and New Storage System With Boot Disk

This checklist is for a new storage system that will contain a Tru64 UNIX boot disk. If you do not want the new storage system to contain a boot disk, use the procedure that starts on page 6-4.

Task		With Access Logix	Reference Document
1	Server	❑ Install the Fibre Channel HBAs.	HBA documentation
	Install HBAs and	❑ Connect a cable from each host HBA port to a switch
	cables
		port.
		❑ Checkpoint — Verify the server connections to the
		switch by checking the LED(s) for the switch port
		connected to each HBA port.
		For a 1-Gbit switch - LED is green, which indicates that
		the HBA is logged in to the switch port.
		For a 2-Gbit switch - One of the following:
		• The left LED is green and the right LED is off, which
		indicates that a 1-Gbit SP port is logged in to the
		switch port.
		• For a DS-xxB2 switch, both LEDs are green, which
		indicates that a 2-Gbit HBA port is logged in to the
		switch port.
		• For a DS-xxM2 switch, the left LED is blue and the
		right LED is off, which indicates that a 2-Gbit HBA
		port is logged in to the switch port.
2	Storage System	❑ Set the Base UDID (UUID on screen) for the storage	Host connectivity guide for Tru64 UNIX
	Set Base UDID	system.	and Tru64 UNIX documentation
		If necessary, you can determine the available UDID
		ranges for the server or cluster with the following
		command:
		wwidmgr -show wwid

6-6

EMC Installation Roadmap for CX-Series and FC-Series Storage Systems