EMC 69001166 Driver- HBA, Documentation see 5-3, update it URL on, Parameters, except for Guide

							Solaris Installation Checklists
				The Without Access Logix column does not apply to CX300, CX500, and
				CX700 storage systems because they ship from the factory with the Access
				Logix enabler installed.
Task		With Access Logix			Without Access Logix			Reference Document
1	Server	❑ If you need additional HBAs to			❑ If you need additional HBAs to			HBA documentation
	Install additional	provide more paths to the storage				provide more paths to the storage		(see URL on page 5-4)
		system, install these HBAs.				system, install these HBAs.
	HBAs
		CAUTION Do not connect cables				CAUTION Do not connect cables
		to the HBAs until you are told to				to the HBAs until you are told to
		do so later in this procedure.				do so later in this procedure.
2	Server	❑ If ATF or CDE is installed, then			❑ If ATF or CDE is installed, then			Removing ATF or CDE
	Remove ATF or	before continuing either remove it				before continuing either remove it
		yourself (see caution before this				yourself (see caution before this
	CDE
		checklist) or arrange to have EMC				checklist) or arrange to have EMC
		Professional Services remove it.				Professional Services remove it.
3	Server	❑ If the following software is			❑ If the following software is			For Emulex or QLogic
	Update Software	currently installed and not at the				currently installed and not at the		driver- HBA
		required minimum revision				required minimum revision		documentation (see
		(page 5-3), update it				(page 5-3), update it:		URL on page 5-4)
		• HBA driver (save the persistent				• HBA driver (save the persistent		For JNI driver- Solaris
			bindings as you will need to			bindings as you will need to		utilities administrator
			add them to the new driver.)			add them to the new driver.		guide
		•	Navisphere Host Agent			• Navisphere Host Agent		CX-Series Server
		•	admsnap					Software for Solaris
								Installation Guide
4	Server	❑ Make sure the HBA driver			❑ Make sure the HBA driver			Solaris host connectivity
	Set HBA driver	parameters, except for the				parameters, except for the		guide
		persistent bindings, are set to the				persistent bindings, are set to the
	parameters							For Emulex or QLogic
		values required for CLARiiON				values required for CLARiiON		HBAs - HBA
		and PowerPath.				and PowerPath.
								documentation (see
		For an Emulex HBA driver, be				For an Emulex HBA driver, be		URL on page 5-4)
		sure to set the following				sure to set the following		For JNI HBAs - Solaris
		parameter:				parameter:
								utilities administrator
		no-device-delay=0				no-device-delay=0
								guide
		CAUTION Using improper				CAUTION Using improper
		settings can cause erratic failover				settings can cause erratic failover
		behavior, such as greatly				behavior, such as greatly
		increased I/O delays.				increased I/O delays.

PowerPath Checklist — Existing Solaris Server and Existing Storage System

5-33