EMC 69001166 manual Navisphere CLI, File is uncommented or commented as described in step

			HP-UX Installation Checklist
Task		With Access Logix		Reference Document
7	Storage System	❑ Use the following Navisphere CLI commands to set the default failover		Navisphere CLI
	Set properties	mode and array commpath properties with the following commands:		reference
		navicli -h hostname failovermode 0
		navicli -h hostname arraycommpath 1
		where hostname is the IP address or network name of an SP in the storage
		system.
8	Storage System	❑ Use Navisphere Manager to set general storage-system properties.		Navisphere Manager
	Configure	❑ Use Navisphere Manager to create RAID Groups, bind LUNs, create		administrator’s guide
				and online help
		Storage Groups, and assign LUNs to Storage Groups.
		❑ Use Navisphere Manager to connect the server to a Storage Group.
9	Server	❑ Log in as root and restart the Navisphere Host Agent with the following		CX-Series Server
	Make LUNs	HP-UX commands:		Software for HP-UX
				Installation Guide
	visible	/sbin/init.d/agent stop
		/sbin/init.d/agent start
		❑ Checkpoint - Verify that HP-UX can recognize these LUNs with the		HP-UX documentation
		following HP-UX commands:
		ioscan -fnC disk
		insf -e
		If HP-UX does not recognize any LUNs, verify the connection to the
		Storage Group.
		❑ Verify that HP-UX sees device entries for all LUNS with the following
		HP-UX command:
		ioscan -fnC disk
		If you do not see two paths to each LUN, verify that the
		OptionsSupported Autotrespass entry in the Host Agent configuration
		file is uncommented or commented as described in step 5.
10	Storage System	❑ Plan your monitoring configuration.		Navisphere Manager
	Set up Event	❑ Use Navisphere Manager to set user options, create templates, and set up		administrator’s guide
				and online help
	Monitor
		your monitoring configuration.

Without EMC Failover Software Checklist - New HP-UX Server and New Storage System

2-57