EMC 69001166 manual ConsoleOne Tools Disk

NetWare Installation Checklists

Task	With Access Logix	Without Access Logix	Reference Document
9 Server	❑ Make sure the SCSISAN.CDM	❑ Make sure the SCSISAN.CDM	NetWare
Install PowerPath	module is not installed.	module is not installed.	documentation
	❑ If the Navisphere Host Agent is	❑ If the Navisphere Host Agent is	CX-Series Server
	running, unload the	running, stop it by unloading the	Software for NetWare
	Navagent.nlm driver with the	Navagent.nlm driver with the	Installation Guide
	command	command
	unload navagent	unload navagent
	❑ Install PowerPath.	❑ Install PowerPath.	PowerPath release
	Note After PowerPath is installed	Note After PowerPath is installed	notes and PowerPath
			for NetWare installation
	on a NetWare 6 server, a device	on a NetWare 6 server, a device	and administrator’s
	named EMC PowerPath Control	named EMC PowerPath Control	guide
	Device appears under	Device appears under
	ConsoleOne > Tools > Disk	ConsoleOne > Tools > Disk
	Management > Devices.This	Management > Devices.This
	device is always inactive and is	device is always inactive and is
	unavailable for I/O.	unavailable for I/O.
	CAUTION If you use the	CAUTION If you use the
	server -nscommand to bring up	server -nscommand to bring up
	NetWare, you must either load	NetWare, you must either load the
	the PowerPath driver manually or	PowerPath driver manually or
	remove all redundant paths.	remove all redundant paths.
	Failure to do so may result in LUN	Failure to do so may result in LUN
	corruption.	corruption.
	❑ Install any PowerPath patches	❑ Install any PowerPath patches from
	from the Software downloads	the Software downloads page on
	page on the EMC Powerlink	the EMC Powerlink website:
	website:	http://powerlink.emc.com
	http://powerlink.emc.com

4-34

EMC Installation Roadmap for CX-Series and FC-Series Storage Systems