EMC 69001166 manual Task With Access Logix, Powermt restore

		Windows Installation Checklists
Task	With Access Logix		Reference Document
25 Server	❑ Identify the HBA or NIC sending I/O to LUN by viewing the output of the
Test PowerPath	powermt display dev=x every=2 command, and disconnect the cable to
	that HBA or NIC.
with a license key
(cont.)	❑ View the output of the powermt display dev=x every=2 command, and
	verify that
	• The state of the uncabled path(s) becomes “dead.”
	• I/O continues to the remaining path(s) to the LUN, indicating that the
	path failover was successful, and PowerPath is working properly.
	❑ Reconnect the cable that you disconnected from the HBA or NIC.
	❑ If you did not follow the above steps exactly and caused any LUNs to
	trespass, restore the LUNs to their original SP with the following PowerPath
	command:
	powermt restore

You are now ready to set up any optional software, such as SnapView or MirrorView, on the storage system.

PowerPath Checklist — New Windows Server and New Storage System

7-13