EMC 69001166 manual HBAs to, Entries for all Luns with, Following HP-UX command

					HP-UX Installation Checklist
Task		With Access Logix	Without Access Logix			Reference Document
10	Server	For a 2-Gbit switch - One of the		For a 2-Gbit switch - One of the		Switch documentation
	Cable additional	following:		following:
	HBAs to	• The left LED is green and the		• The left LED is green and the
	switches or	right LED is off, which indicates		right LED is off, which indicates
	storage system	that a 1-Gbit SP port is logged		that a 1-Gbit SP port is logged
	(cont.)	in to the switch port.		in to the switch port.
		• For a DS-xxB2 switch, both		• For a DS-xxB2 switch, both
		LEDs are green, which		LEDs are green, which
		indicates that a 2-Gbit HBA		indicates that a 2-Gbit HBA
		port is logged in to the switch		port is logged in to the switch
		port.		port.
		• For a DS-xxM2 switch, the left		• For a DS-xxM2 switch, the left
		LED is blue and the right LED		LED is blue and the right LED
		is off, which indicates that a		is off, which indicates that a
		2-Gbit HBA port is logged in to		2-Gbit HBA port is logged in to
		the switch port.		the switch port.
11	Switches	For a SAN	For a SAN			Switch management
	Zone	❑ Zone the switches to provide a	❑ Zone the switches to provide a			documentation
		path from each HBA port (host		path from each HBA port (host
		initiator) to the appropriate SPs.		initiator) to the appropriate SPs.
		❑ Checkpoint - Use switch	❑	Checkpoint - Use switch
		management software to verify		management software to verify
		the switch connections to the		the switch connections to the
		storage system.		storage system.
12	Server	❑ Make sure that each HBA sees	❑ Verify that each HBA sees only			HP-UX documentation
	Make target SPs	only the targets (SPs) to which it		the targets (SPs) to which it is
	available	is zoned with the following HP-UX		zoned with the HP-UX following
		commands:		commands:
		ioscan -fnC disk		ioscan -fnC disk
		insf -e		insf -e
		❑ Verify that HP-UX sees device	❑ Verify that HP-UX sees device
		entries for all LUNS with the		entries for all LUNS with the
		following HP-UX command:		following HP-UX command:
		ioscan -fnC disk	❑	ioscan -fnC disk
		❑ Log in as root and restart the	❑ Log in as root and restart the			CX-Series Server
		Navisphere Host Agent with the		Navisphere Host Agent with the		Software for HP-UX
		following HP-UX commands:		following HP-UX commands:		Installation Guide
		/sbin/init.d/agent stop		/sbin/init.d/agent stop
		/sbin/init.d/agent start		/sbin/init.d/agent start

PowerPath Checklist - Existing HP-UX Server and Existing Storage System

2-41