EMC 69001166 manual Storage-system management ports Guide

Solaris Installation Checklists

Task		With Access Logix	Reference Document
7	Storage System	❑ Install the Navisphere Initialization Utility on a host on the same subnet as	Storage-system setup
	Initialize and install	the storage-system management ports.	guide
	software enablers	❑ Use the Navisphere Initialization Utility to initialize the storage system.
		❑ If you have SAN Copy, SnapView, MirrorView, and/or MirrorView/A	Navisphere Manager
		software, install their enablers.	administrator’s guide
			and online help
8	Storage System	❑ Connect the storage system to the switch or HBA ports.	Storage-system setup
	Cable to switch or		guide
	server and LAN	❑ Checkpoint - For a SAN, verify the storage-system connections to the
		switch by checking the LED(s) for the switch port connected to each SP
		port.
		For a 1-Gbit switch - LED is green, which indicates that the SP is logged
		in to the switch port.
		For a 2-Gigabit switch - One of the following:
		• The left LED is green and the right LED is off, which indicates that a
		1-Gbit SP port is logged in to the switch port.
		• For a DS-xxB2 switch, both LEDs are green, which indicates that a
		2-Gbit HBA port is logged in to the switch port.
		• For a DS-xxM2 switch, the left LED is blue and the right LED is off,
		which indicates that a 2-Gbit HBA port is logged in to the switch port.
		❑ Cable each SP to the LAN connected to the hosts from which you will	Storage-system setup
		manage the storage system.	guide
9	Storage System	❑ Use Navisphere Manager to define a global administrator and domain (if	Navisphere security
	Set up security	not already defined) and any additional users.	administrator’s guide
			and Navisphere
			Manager online help
10	Set Properties for	❑ Use the following the following Navisphere CLI commands to set the	Navisphere CLI
	PowerPath	following default storage-system properties:	reference
		navicli -h hostname systemtype -config 3
		navicli -h hostname failovermode 1
		navicli -h hostname arraycommpath 1
		navicli -h hostname unitserialnumber lun (only for server in a Sun
		Cluster; it must left at the default setting for all other cases)
		where hostname is the IP address or network name of an SP in the storage
		system.

PowerPath Checklist — Existing Solaris Server and New Storage System

5-27