EMC 69001166 manual With the following NetWare command, Unload navagent

NetWare Installation Checklists

Task		With Access Logix	Reference Document
6	Server	❑ Make sure the SCSISAN.CDM module is not installed.	NetWare documentation
	Install PowerPath	❑ If the Navisphere Host Agent is running, unload the Navagent.nml driver	CX-Series Server
		with the following NetWare command:	Software for NetWare
		unload navagent	Installation Guide
		❑ Install PowerPath.	PowerPath release
		Note After PowerPath is installed on a NetWare 6 server, a device named	notes and PowerPath for
			NetWare installation and
		EMC PowerPath Control Device appears under ConsoleOne > Tools >	administrator’s guide
		Disk Management > Devices.This device is always inactive and is
		unavailable for I/O.
		CAUTION If you use the server -nscommand to bring up NetWare, you
		must either load the PowerPath driver manually or remove all redundant
		paths. Failure to do so may result in LUN corruption.
		❑ Install any PowerPath patches from the Software downloads page on the
		EMC Powerlink website:
		http://powerlink.emc.com
7	Storage System	❑ Install the storage system in the cabinet, if not already installed.	Rails and cabinet
	Install		documentation
8	Storage System	❑ Install the Navisphere Initialization Utility on a host on the same subnet as	Storage-system setup
	Initialize and	the storage-system management ports.	guide
	install software	❑ Use the Navisphere Initialization Utility to initialize the storage system.
	enablers
		❑ If you have SAN Copy, SnapView, MirrorView, and/or MirrorView/A	Navisphere Manager
		software, install their enablers.	administrator’s guide
			and online help
9	Storage System	❑ Connect the storage system to the switch or HBA ports.	Storage-system setup
	Cable to switch		guide.
	or server and	❑ Checkpoint - For a SAN, verify the storage-system connections to the
	LAN
		switch by checking the LED(s) for the switch port connected to each SP
		port.
		For a 1-Gbit switch - LED is green, which indicates that the SP is logged
		in to the switch port.

PowerPath Checklist — Existing NetWare Server and New Storage System

4-23