EMC 69001166 manual Switches For a SAN, Software, install their enablers

Linux Installation Checklist

Task		With Access Logix	Reference Document
5	Switches	For a SAN	Rails, cabinet, and
	Install	❑ Install switches, if not already installed.	switch documentation
		❑ Connect a cable from each host HBA port to a switch port.
		❑ Checkpoint - Verify the HBA connection to the switch by checking the
		LED(s) for the switch port connected to the HBA port.
		For a 1-Gbit switch - LED is green, which indicates that the HBA is
		logged in to the switch port.
		For a 2-Gbit switch - One of the following:
		• The left LED is green and the right LED is off, which indicates that a
		1-Gbit SP port is logged in to the switch port.
		• For a DS-xxB2 switch, both LEDs are green, which indicates that a
		2-Gbit HBA port is logged in to the switch port.
		• For a DS-xxM2 switch, the left LED is blue and the right LED is off,
		which indicates that a 2-Gbit HBA port is logged in to the switch port.
6	Storage System	❑ Install the storage system in the cabinet, if not already installed.	Rails and cabinet
	Install		documentation
7	Storage System	❑ Install the Navisphere Initialization Utility on a host on the same subnet as	Storage-system setup
	Initialize and	the storage-system management ports.	guide
	install software	❑ Use the Navisphere Initialization Utility to initialize the storage system.
	enablers
		❑ If you have SAN Copy, SnapView, MirrorView, and/or MirrorView/A	Navisphere Manager
		software, install their enablers.	administrator’s guide
			and online help

3-8

EMC Installation Roadmap for CX-Series and FC-Series Storage Systems