EMC 69001166 manual Storage Group Use Navisphere Manager to, Group Reboot the server using

						Solaris Installation Checklists
Task		With Access Logix		Without Access Logix			Reference Document
12	Server	❑	Checkpoint - Use the inquiry	❑	Checkpoint - Use the inquiry		Solaris documentation
	Make target SPs		option of the format command to		option of the format command to
			verify the paths to the storage		verify the paths to the storage
	available (cont.)
			system. Alternate paths will have		system. Alternate paths will have
			a device with an ID of drive type		a device with an ID of drive type
			unknown.		unknown.
			Note The format command will		Note The format command will
			display n+1 device entries for		display n+1 device entries for
			each LUN, where n is the number		each LUN, where n is the number
			of paths to the LUN. One of these		of paths to the LUN. One of these
			entries is a PowerPath device and		entries is a PowerPath device and
			the other n entries are native		the other n entries are native
			devices.		devices.
13	Storage System	❑ If the server will use an existing					Navisphere Manager
	Configure		Storage Group, use Navisphere				administrator’s guide
			Manager to connect the server to				and online help
			the Storage Group.
		❑ If the server will use a new
			Storage Group, use Navisphere
			Manager to create RAID Groups,
			bind LUNs, create the Storage
			Group, and assign LUNs to the
			Storage Group.
		❑ Use Navisphere Manager to
			connect the server to the Storage
			Group.
		❑ Reboot the server using the		❑ Reboot the server using the			Solaris documentation
			reboot - - -rcommand so that		reboot - - -rcommand so that
			Solaris recognizes the LUNs.		Solaris recognizes the LUNs.
			Now the LUNs in the Storage		Now the LUNs look like any other
			Group look like any other disks in		disks in the server.
			the server.
		❑	Checkpoint - Use the format	❑	Checkpoint - Use the format
			command to verify that Solaris		command to verify that Solaris
			recognizes the LUNs.		recognizes the LUNs.
			If Solaris does not recognize any
			LUNs, verify the connection to the
			Storage Group.
		❑ For an FC4500, disconnect the		❑ For an FC4500, disconnect the			Storage-system setup
			computer from the serial port on		computer from the serial port on		guide
			the storage system.		the storage system.

PowerPath Checklist — New Solaris Server and Existing Storage System

5-21