EMC 69001166 manual Zone additional, Driver configuration file

Solaris Installation Checklists

Task		With Access Logix	Reference Document
11	Server	❑ Cable any additional HBA ports to the switch connected to the storage	Storage-system setup
	Cable additional	system or to SP ports.	guide.
	HBAs to switches	❑ Checkpoint - For a SAN, verify the HBA connections to the switch by
	or storage system
		checking the LED(s) for the switch port connected to each additional HBA
		port.
		For a 1-Gbit switch - LED is green, which indicates that the HBA port is
		logged in to the switch port.
		For a 2-Gigabit switch - One of the following:
		• The left LED is green and the right LED is off, which indicates that a
		1-Gbit SP port is logged in to the switch port.
		• For a DS-xxB2 switch, both LEDs are green, which indicates that a
		2-Gbit HBA port is logged in to the switch port.
		• For a DS-xxM2 switch, the left LED is blue and the right LED is off,
		which indicates that a 2-Gbit HBA port is logged in to the switch port.
12	Switches	For a SAN	Switch management
	Zone additional	❑ Zone the switches to provide a path from each additional HBA port (host	documentation
	HBAs	initiator) to the SPs.
		❑ If SAN Copy, MirrorView, or MIrrorView/A is installed, create any required
		zones.
		❑ Checkpoint - Use switch management software to verify the switch
		connections to the storage system.
13	Server	❑ Add persistent bindings for the new SPs and any new HBAs to the HBA	Solaris utilities kit
	Make target SPs	driver configuration file.	administrator’s guide
	available	Note Removing ATF does not remove or change the persistent bindings.
		❑ Edit the /kernel/drv/sd.conf file to add LUNs and their targets.	Solaris driver.conf
			man page
		❑ Reboot the server using the reboot - - -rcommand so the HBA can see	Solaris documentation
		the targets (SPs).
		❑ Checkpoint - Verify that each HBA sees only the targets (SPs) to which it
		is zoned.
		❑ Checkpoint - Use the inquiry option of the format command to verify that
		each path to the storage system has one arraycommpath device with an ID
		of drive type unknown.
		The output of this command should be Vendor DGC, Product LUNZ.

5-28

EMC Installation Roadmap for CX-Series and FC-Series Storage Systems