EMC 69001166 manual For new HBAs For any HBAs Navisphere CLI, Navicli -np -d device Systemtype

Linux Installation Checklist

Task	With Access Logix	Without Access Logix	Reference Document
6 FC4500 Storage	❑ Connect a computer to the serial	❑ Connect a computer to the serial	Storage-system setup
System	port on the storage system.	port on the storage system.	guide
Set properties for	For new HBAs	For any HBAs	Navisphere CLI
PowerPath			reference
	❑ From the computer connected to	❑ From the computer connected to
	the storage system’s serial port,	the storage system’s serial port,
	use the following Navisphere CLI	use the following Navisphere CLI
	command to determine the	command to determine the
	default storage-system type:	default storage-system type:
	navicli -np -d device	navicli -np -d device
	systemtype	systemtype
	where device is the name of the	where device is the name of the
	computer port connected to the	computer port connected to the
	storage-system serial port (for	storage-system serial port (for
	example, com1).	example, com1).
	If the default storage-system	If the default storage-system
	system type is not 3 (CLARiiON	system type is not 3 (CLARiiON
	Open), use the following	Open), use the following
	Navisphere CLI command to set	Navisphere CLI command to set
	it to 3:	it to 3:
	navicli -np -d device	navicli -np -d device
	systemtype -config 3	systemtype -config 3
	CAUTION The above command	CAUTION The above command
	reboots both SPs at the same	reboots both SPs at the same
	time.	time.
	❑ From the computer connected to	❑ From the computer connected to
	the storage system’s serial port,	the storage system’s serial port,
	use the following Navisphere CLI	use the following Navisphere CLI
	commands to set the following	commands to set the following
	default storage-system	default storage-system
	properties:	properties:
	navicli -np -d device	navicli -np -d device
	failovermode 1	failovermode 1
	navicli -np -d device	navicli -np -d device
	arraycommpath 1	arraycommpath 1
	where device is the name of the	where device is the name of the
	computer port connected to the	computer port connected to the
	storage-system serial port (for	storage-system serial port (for
	example, com1).	example, com1).

3-32

EMC Installation Roadmap for CX-Series and FC-Series Storage Systems