EMC 69001166 Values required for, CLARiiON, Guide0, Software Installation, Prompts you to reboot

Windows Installation Checklists

Task		With Access Logix	Without Access Logix	Reference Document
3	Server	❑ Set the HBA driver parameters to	❑ Set the HBA driver parameters to	Host connectivity guide
	Set HBA driver	the values required for	the values required for	and HBA documentation
		CLARiiON.	CLARiiON.	(for HBAs, see URL on
	properties
				7-5)
		CAUTION Using improper	CAUTION Using improper
		settings can cause erratic failover	settings can cause erratic failover
		behavior, such as greatly	behavior, such as greatly
		increased I/O delays.	increased I/O delays.
4	Server	❑ Install PowerPath.	❑ Install PowerPath.	PowerPath release
	Install PowerPath	❑ Reboot the server to complete	❑ Reboot the server to complete	notes and PowerPath for
				Windows installation
		the installation of PowerPath.	the installation of PowerPath.	and administrator’s
		Contrary to what the PowerPath	Contrary to what the PowerPath	guide0-
		documentation states, PowerPath	documentation states, PowerPath
		will not see any logical disks	will not see any logical disks
		(LUNs) in the storage system at	(LUNs) in the storage system at
		this point because the storage	this point because the storage
		system has not been connected.	system has not been connected.
		❑ Install any PowerPath patches	❑ Install any PowerPath patches
		from the Software downloads	from the Software downloads
		page on the EMC Powerlink	page on the EMC Powerlink
		website:	website:
		http://powerlink.emc.com	http://powerlink.emc.com
5	Server	❑ Install the Navisphere Host Agent	❑ Install the Navisphere Host Agent	CX-Series Server
	Install Host	or Navisphere Server Utility and	or Navisphere Server Utility and	Software Installation
		Navisphere CLI.	Navisphere CLI.	guide for Windows or
	Agent or Server
				Windows Agent and CLI
	Utility	❑ For a CX500i storage system,
				installation guide
		reboot server either after the Host
		Agent installation is complete or
		when the Server Utility dialog
		prompts you to reboot.
		If you do not reboot before you
		run the Microsoft iSCSI Software
		Initiator to configure iSCSI NIC
		initiators, the initiators will not log
		in to the storage system.

PowerPath Checklist — New Windows Server and Existing Storage System Without Boot Disk

7-15