EMC 69001166 manual Use the following PowerPath command to configure PowerPath

			HP-UX Installation Checklist
Task		With Access Logix		Reference Document
18	Server	❑ Use the following PowerPath command to configure PowerPath:		PowerPath product
	Configure	powermt config		guide
	PowerPath
	devices	❑ Checkpoint - Use the following PowerPath command to verify that
		PowerPath sees all the paths to the LUNs:
		powermt display dev=all class=clariion
		If PowerPath cannot see all the paths, verify that
		• you registered your PowerPath license key if you have one
		• the OptionsSupported Autotrespass entry is defined as described in
		step 5.
		• the storage-system properties are set as defined in step 11.
		❑ If PowerPath can see all the path to the LUNs, save the PowerPath
		configuration with the following command:
		powermt save
		The PowerPath configuration is saved in the following file:
		/etc/powermt.custom
19	Server	If you have a PowerPath license key		PowerPath product
	Test PowerPath	Note If your PowerPath license key is not registered, the load balancing policy is		guide
	with a license	restricted to basic failover.
	key
		❑ View the LUNs available to the server using the following PowerPath
		command:
		powermt display dev=all class=clariion
		❑ Choose one available LUN to receive I/O for the test.
		❑ View the paths to the chosen LUN using the following PowerPath
		command:
		powermt display dev=x every=2
		where x is a device that represents the chosen LUN.
		❑ Start I/O to the LUN.
		❑ Identify the HBA sending I/O to LUN by viewing the output of the powermt
		display dev=x every=2 command, and disconnect the cable to that HBA.

PowerPath Checklist - Existing HP-UX Server and New Storage System

2-31